KICHLER Dover 6.25-in 1-Light Brushed Nickel Transitional Vanity Light Instruction Manual
- June 9, 2024
- KICHLER
Table of Contents
Dover 6.25-in 1-Light Brushed Nickel Transitional Vanity Light
Instruction Manual
CAUTION RISK OF SHOCK
Disconnect Power at the main circuit breaker panel or main fuse box before starting and during the installation.
-
Thread hexnut onto threaded pipe so that 5 threads are exposed below hexnut. From underside of mounting strap, thread long end of threaded pipe into hole in mounting strap until hexnut touches mounting strap. Tighten hexnut against mounting strap.
-
Thread second hexnut onto other end of threaded pipe.
Tighten hexnut up against mounting strap. -
Attach mounting strap to outlet box with strap mounting screws
-
Grounding instructions: (See Illus. A or B)
A) On fixtures where mounting strap is provided with a hole and two raise dimples. Wrap ground wire from outlet box around green ground screw, and thread into hole.
B) On fixtures where a cupped washer is provided. Put ground wire from outlet box under cupped washer and green ground screw and thread screw into hole in mounting strap.
If fixture is provided with ground wire. Connect fixture ground wire to outlet box ground wire with wire connector, after following the above steps. Never connect ground wire to black or white power supply wires.
-
Make wire connections. Reference chart below for correct connections and wire accordingly.
Connect Black or Red Supply Wire to:| Connect White Supply Wire to:
---|---
Black| White
Parallel cord (round & smooth)| Parallel cord (square & ridged)
Clear, Brown, Gold or Black without tracer| Clear, Brown, Gold or Black with tracer
Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
Note: When parallel wires (SPT I & SPT II) are used. The neutral wire is square shaped or ridged and the other wire will be round in shape or smooth (see illus.)
- Push fixture to wall carefully passing threaded pipe through hole in canopy. Make sure all wires are inside canopy and do not get pinched between wall and canopy of fixture.
- Screw lockup knob onto threaded pipe. Tighten lockup knob to secure fixture to wall.
- Set glass down over socket. Pass hole in glass over socket and rest on glass cup.
- Thread socket ring onto socket. Tighten socket ring to secure glass in place. (DO NOT over tighten.)
- Insert recommended bulb(s). (Not included)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>