EATON AG II IT DN0xx Series Surge Protection and Filtering Instruction Manual
- June 9, 2024
- EATON
Table of Contents
- EATON AG II IT DN0xx Series Surge Protection and Filtering
- ABOUT COMPANY
- INTERNAL CONFIGURATION
- INSTALL. CROSS SECTION / PRODUCT VERSIONS
- TECHNICAL DATA
- CONNECTION
- CORRECT CABLE ROUTING
- WRONG CABLE ROUTING
- MODULE REPLACEMENT
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
EATON AG II IT DN0xx Series Surge Protection and Filtering
ABOUT COMPANY
- Eaton Corporation, 1000 Eaton Boulevard, Cleveland, OH 44122, United States
- © 2022 by Eaton, www.eaton.com
- 03.2022a / All Rights Reserved
- For more information, please contact the Eaton Technical Resource Center at 1-800-809-2772, option 4, option 2. You may submit inquiries via email to spd@eaton.com and you can find more information at eaton.com/aegis.
Please read the following before installing your Surge Protective Device:
- Verify the system voltage and configuration on the label is appropriate for the application.
- Risk of Electric Shock – Installation and maintenance should be performed by qualified personnel only.
- Safety rules and regulations applicable to all devices connected to power lines should always be followed. National standards and safety regulations must be followed.
- The external mechanical integrity of the device must be checked before installation. Products with visible damage should not be installed.
- Its use is only permitted within the limits shown and stated in these installation instructions. Opening or tampering with the device invalidates the warranty.
- It is very important to ensure the new device is of the same type and voltage as that being replaced.
INTERNAL CONFIGURATION
INSTALL. CROSS SECTION / PRODUCT VERSIONS
TECHNICAL DATA
CONNECTION
CORRECT CABLE ROUTING
WRONG CABLE ROUTING
MODULE REPLACEMENT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>