VISUAL COMFORT CW1121 Wellfleet Single Arm Cone Task Sconce Instruction Manual

Installation Instructions for
WELLFLEET1A-WALL
Wellfleet 1 Arm Wall
C 1121, C 1131, CW1141 1.1

ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant junction boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
This instruction shows a typical installation.

CAUTION RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°C supply conductors.

SAVE THESE INSTRUCTIONS!

Install the Fixture

For Standard Wiring:

1. Secure the mounting plate to the junction box.

2. Screw the cap into the hole in the bottom of the backplate.

3. Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.

4. Connect the white fixture wire to the neutral power line wire with a wire nut.

5. Connect the black fixture wire to the hot power line wire with a wire nut.
   For Plug-in:

6. Secure the mounting plate to the wall.

7. Feed the cord though the stem and through the hole in the bottom of the backplate.

8. Screw the stem into the bottom of the backplate.

9. Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.

10. Connect the white fixture wire to the neutral cord wire (square and/or rigid) with a wire nut.

11. Connect the black fixture wire to the hot cord wire (round and/or smooth) with a wire nut.
    For Both:

12. Properly place all wires and wire nut connections into the junction box/fixture base, mount the fixture onto the mounting plate/fixture bracket, and secure it in place using the fixture screws.

13. Install the shade by aligning the holes on the shade with the holes on the bracket and the socket, then secure in place using the shade screws.

14. Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.

15. Adjust the fixture arm as needed.

GENERATION LIGHTING
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.

References

• Generation Lighting Collection | Visual Comfort & Co.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>