premio MDG200 4G LTE Modem Installation Guide
- June 9, 2024
- premio
Table of Contents
premio MDG200 4G LTE Modem
Follow the steps below to configure the AMIT LTE modem with your SIM card
- Determine if your unit comes with an external SIM slot
- If yes, go to section 1.0 on how to configure the modem with an EXTERNAL SIM slot
- If no, go to section 2.0 on how to configure the modem with an INTERNAL SIM slot
- To find the modem’s IMEI number, go to section 3.0
- See attached PDF file for the complete AMIT user’s manual
SIM Card Installation For External SIM Slot
- Check to determine if the unit comes with an EXTERNAL SIM slot
- If an external SIM slot is present, you will need to configure the LTE modem for external SIM slot usage
- Power up the unit and boot into the OS
- From a browser, go to 172.16.0.1 and login as admin/admin
- It will prompt you to change the default admin password. Note the new password requirement below:
- To configure the SIM slot to external, go to Setup / Network / Cellular; change SIM Select to External and click on SAVE at the bottom:
- Power off the unit and DISCONNECT THE POWER CORD
- Locate the SIM slot on the unit and insert the SIM card
- Reconnect the power cord and power on the unit
SIM Card Installation For Internal SIM Slot
- If your unit does not come with an external SIM slot, you will need to install the SIM card internally to the modem
- Consult the user’s manual on how to open up the unit to get access to the LTE modem
- Locate AMIT modem and the 1x screw; note, there may be 2x screw on some unit
- Carefully lift up the modem to detach it from the bottom mPCIe carrier board:
- The modem requires a nano SIM as shown below:
- The SIM slot is located at the bottom of the modem:
- Note the alignment of the notch on the SIM card into the SIM slot during installation
- Re-install the modem back to the mPCIe carrier board and re-install the screw(s)
- Close up the unit
IMEI Number
- Some carriers may require the modem’s IMEI number to be associated with the SIM card’s number
- To find the modem’s IMEI number, login via the webGUI and go to Status / Cellular / Modem:
Appendix
- This module does NOT support fail-over with multiple SIM; only one SIM could be supported at a time
- eSIM is NOT supported
- GPS is supported, but will require an additional external GPS antenna to enable it
ATTENTION-observe precautions for handling electros tatic sensitive devices
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>