MIDLAND R Series Helmet Intercom Device Installation Guide
- June 8, 2024
- MIDLAND
Table of Contents
MIDLAND R Series Helmet Intercom Device
MOUNTING KIT
Place the intercom device on the left side of your helmet using the adhesive mount or the clamp mount.
Adhesive mount
Clean the surface and keep pressed for 10 seconds to fix the mount.
Clamp mount
Lock
Overlap and slide downwards.
Unlock
Press (with a pointed object) and slide upwards.
SPEAKERS
The speakers’ positioning is the most important point of the installation
procedure.
Attention: for the best sound clarity it is very important to place the
speakers in correspondance with the centre of your ears and as close as
possible (the speakers must almost touch your ears). In case of need, use the
supplied spacers to better fit the speakers closer to your ears. The recesses
of the speakers designed into the helmets are not always placed in the best
location for you. Please be sure to fix speakers properly.
RCF CUSHIONS*
To improve the sound experience, you can use the RCF cushions. They can be
installed or removed afterwards.
Attention: although the RCF cushions have been designed to guarantee a
high-level comfort, please verify that there’s enough space into your helmet
and that they can fit well.
- for models supplied with RCF cushions
MICROPHONES
Wired microphone for full face helmets: place the microphone in front of
your mouth.
Boom microphone for modular/jet helmets: fix the mike on the left side
and keep the sponge as closely as possible to your mouth (white symbol in
front of your mouth).
LOCK/UNLOCK
To fix the intercom device to the MAGic LOCK mount:
Insert at first the rear side of the unit into the mount by tilting the unit
of 45° and then bring nearer the fore side: the strong magnet will lock safely
the device.
To unlock the intercom device:
press the bottom on the bottom side of the clip (A) and pull out the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>