eta 4166740 Electric Slicer Instruction Manual

: June 9, 2024
: ETA

Table of Contents

4166740 Electric Slicer
SAFETY WARNING
FEATURES OF THE DEVICE
PREPARATION FOR USE
USING THE CUTTER
MAINTENANCE
ENVIRONMENTAL PROTECTION
TECHNICAL DATA
Documents / Resources

Electric slicer
INSTRUCTIONS FOR USE eta 4166740 Electric Slicer

4166740 Electric Slicer

eta 4166740 Electric Slicer - Figure 1

Dear customer, thank you for purchasing our product. Please read the operating instructions carefully before putting the appliance into operation and keep these instructions including the warranty, the receipt and, if possible, the box with the internal packing.

SAFETY WARNING

Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
Check whether the data on the type label corresponds with the voltage in your socket.
The power cord plug may only be connected to the electrical socket complying with the applicable standards.
This appliance must not be used by children. Keep the device and its supply cord out of reach of children. The device may be used by persons with reduced physical or mental abilities or lack of experience and knowledge only if they are under supervision or they have been instructed about using the appliance safely and understand the potential dangers. Children must not play with the appliance.
Before replacing accessories or accessible parts, which move during operation, before assembly and disassembly, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
Always unplug the appliance from power supply if you leave it unattended and before assembly, disassembly or cleaning.
Round knife is sharp. Care is needed when handling round knife, especially when removing the blades from its mount and during cleaning.
If the power cord of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.
Never use the appliance if the power cord or power plug are damaged, if the appliance is not correctly operating or if it has fallen on the floor and been damaged, or if it has fallen into water. In such cases take the appliance to a professional service centre to verify its safety and correct function.
CAUTION: Do not use the appliance with a program, time switch or any other part that turns the appliance on automatically as there is a risk of fire if the appliance is not covered or placed properly.
When the appliance is in operation, prevent pets, plants or insects from getting in contact with it.
Do not plug the power cord in the electrical socket and do not unplug it with wet hands or by pulling the power cord!
The appliance is intended for home use and for similar purposes (in shops, offices and similar sites, in hotels, motels and other residential premises, or in facilities providing bed and breakfast service). It is not intended for commercial use!
This appliance is not intended for outdoor use.
Do not use the appliance in an environment saturated with explosive or flammable steams.
Never leave the running appliance unattended and keep an eye on it during the whole process of food preparation!
Never immerse the appliance into water or wash it in running water!
Use the appliance in the working position at places with no risk of turning over and in sufficient distance from flammable objects (e.g. curtains, drapes, wood, etc.), heat sources (e. g. heater, stove, etc.) and wet surfaces (e.g. sinks, wash–basins, etc.).
Before plugging the appliance to power supply, always check whether the knife is attached properly.
Never put fingers into the knife area or use e.g. a fork or a knife to do so. In order to move food towards the knife, always use the sliding plate with the attached pusher plate if possible, given the size or shape of foodstuff.
Use the slicer only for slicing defrosted food! Do not use it for slicing dry, hard bakery products and bread, smoked meat with bones or meat with bones, fruit with hard stones, food packed in aluminium foil or plastic foil.
Always switch off the slicer if you wish to set the slice thickness or take out the knife.
Before taking out the food, let the rotating knife stop completely first. After switching the drive off, it runs down for a short time. After the operation, set the slice thickness regulator to position P.
Do not exceed the maximum continuous operating time of the appliance, it´s 5 min.
Make sure that the power supply cable does not get in between the rotating parts of the appliance.
Never put the power cord on hot surfaces and never let it hang over table edge or worktop edge. If the cord is caught or pulled, e.g. by children, the appliance may overturn and fall down, causing a serious injury!
The power cord must not be damaged with sharp or hot objects, open fire, it must not be sunk into water or bent over sharp edges.
If you need to use an extension cord for justified reasons, it must be undamaged and comply with the applicable standards.
Use only designated accessories enclosed. Using other types of accessories can present a risk for the operator.
Only use this appliance for the purpose it was designed for, as specified in this manual.
Never use the appliance for any other purpose.
The producer does not undertake any responsibility for damage or injuries caused by improper use of the appliance and the accessories (e.g. food deterioration, injuries,
cuts) and its guarantee does not cover the appliance in the case of failure to comply with the safety warnings above.

FEATURES OF THE DEVICE

(Fig. 1)

A – slicer
A1 – main switch I/O
A2 – slice thickness knob
A3 – strip thickness indicator (reference scale)
A4 – power cord| B – cutting knife
B1 – nut
C – feeder
C1 – slider with food hold
D – removable tray
---|---

PREPARATION FOR USE

Remove all packaging material, remove the accessory. Remove all adhesive foils, stickers or paper from the appliance. Wash the parts which will come in contact with the food in hot water with soap before first use.
Appliance assembly
When assembling the appliance, follow the procedure indicated in Fig. 1. For disassembly proceed in reverse order.

USING THE CUTTER

Switching the appliance on/off

Position “I”	– appliance ON
Position “O”	– appliance OFF

Setting the slice thickness
By turning the knob slightly to the left/right, you can set the slice thickness from 0 to 15 mm (see Fig. 1).
PROCEDURE FOR USE:

When assembled, place the slicer on a suitable and flat worktop with good surface adhesion.
Set the slice thickness as required.
Connect the slicer to the mains.
Put the required food in the feeder C, switch the slicer on and start slicing while applying slight pressure and moving smoothly.
When finished, switch the slicer off and unplug it from the mains.

Note
When slicing, we recommend that you keep turning the food as you go along.
Caution
The cutter can be used with the feeder without the slider C1. In such a case, pay extra care so as not to injure your hand or fingers!

Ingredient	Recommended slice thickness of the cut food.
pastry, bread	10 mm
cheese, smoked goods (soft salami)	2 mm (wet the knife with cheese so that

the slices do not stick)
smoked goods (ham, flitch)| 2 mm
smoked goods (dry-hard salami.| 2 mm

MAINTENANCE

To clean the surface of the slicer and power cord, use a wet cloth. Do not use rough and abrasive cleaning agents (e.g. sharp objects, scrapers, diluents or other dissolvents)!
Taking out and cleaning the knife (Fig. 2)
Turn the locking screw in the direction of the arrow as far as it goes . Release it from its position by slight pressure on the knife from the opposite side and after that take the knife out of the slicer. Do not wash the knife in a washing bath as the grease would be removed from it. Only wipe the outer edge by wet cloth or paper towel. Be very careful when cleaning the slicing knife! Ensure that the cutting edges of the knife do not come in contact with hard objects which make them blunt and thus reduce their efficiency. Clean the area behind the slicing knife by a soft brush or wet cloth. Attach the knife back after cleaning and fasten it properly the other way round.
Disassembly of feeder C
To eject, set the A2 controller to position “P”, this releases the safety catch and the feeder can be ejected.
Plastic parts
Rinse the plastic parts (C1, D) in warm water with detergent (or use a dish- washer).

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are labels of materials used for production of packing, components and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal of the product, hand it over at special collection places where it will be received free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Ask for more details at the local authorities or at a collection site. Fines can be imposed for improper disposal of this type of waste in agreement with the national regulations. If the appliance is to be put out of operation, after disconnecting from power supply we recommend its cutoff and in this way it will not be possible to use the appliance again.

TECHNICAL DATA

Voltage (V)	shown on the type label of the appliance
Input (W)	shown on the type label of the appliance
Slicing regulation (mm)	0-15
Weight (kg) approx.	4.3
Size of the product (mm)	352 x 288 x 245
Input in off mode is <0,50 W.

Acoustic noise level of 75 dB(A) re 1pW
The manufacturer reserves the right to change the technical specifications and accessories for the respective models.
Replacement of parts that require intervention in the electric part of the appliance must be carried out by a specialized service! Failure to comply with the instructions of the manufacturer will lead to expiration of the right to guarantee repair!
WARNINGS AND SYMBOLS USED ON THE APPLIANCE, PACKAGING OR IN THE INSTRUCTIONS MANUAL:
HOUSEHOLD USE ONLY; DO NOT IMMERSE IN WATER OR OTHER LIQUIDS;
TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.
The symbol indicates a WARNING.
release this way

© DATE 28/8/2018
e.č.56/2018