REVOLT TG1020 Vapor Racer User Manual

REVOLT TG1020 Vapor Racer

Introduction

PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE.

The materials, specifications, parts and packaging mentioned in this manual are for reference purposes only. We are not responsible for any changes made to this printed material, nor are we able to inform customers of any updates or changes. Please refer to our website: R3VOLT.COM for the latest information.

Important Safety Information

Thank you for buying this REVOLT item. To ensure that you operate the vehide correctly, please read these instructions carefully before first use and store them in a safe place for future reference.

Safety information

• Keep the smaller-sized accessories out of the reach of children.

• Do not store batteries in a hot environment (e g near open flames or a heating device) ‘Children must be supervised by an adult when operating the vehicle. The vehicle should always remain within the line of Sight of the driver (or instructor).

• Do not recharge non-rechargeable batteries. When installing or changing the batteries, ensure that they are connected in the correct polarity. Do not mix old and new batteries or different types of batteries.
  ‘Do not short circuit the battery terminals.

• If you do not plan to use the vehicle for at least 10 days, discharge the battery to 40%-50% (1.e. 1f the battery is fully charged, drive the vehicle for half of the total dr1v111g time). This helps to prolong the lifespan of the battery.
  ‘You must only use the dharging cable provided Disconnect the charging cable from the vehicle before cleaning.
  Regularly inspect the charging cable’s wires, plug socket. outer casing and other accessories to ensure they are not damaged. If there are any signs of damage, discontinue use immediately until repa,red.

• After use, ensure that the vehicle and remote control are switched off and remove the batteries in the remote control.
  ‘ The packaging and this manual contain important information and should be kept in a safe place for future reference.

Repair And Maintenance

• clean the product regularly with a clean, soft cloth
• Avoid exposing the product to direct sunlight or heat.
• Do not submerge the product in water, as this may damage the electrical components.

About This Product

Specifications

Remote controlled vehicle

Weight 186g
Dimensions 20.3×8.9×5.9cm
Remote control range    15-20 meters
Charging time about  140 mins
Operating tim e   15-20 mins
Battery 3. 7V 500mAh rechargeable battery (included)

Remote control

Operating frequency 2.4 GHz
Battery Requirements 2xAA 1.5V batteries (not included)

OPERATING INSTRUCTIONS

• Use 2x AA 1.5V non-rechargeable batteries (not included).
  

• Rechargeable battery pack connector
  

• Make sure the car power switch is in the ‘OFF’ position before charging.
  

• Calibration dial: Adjust the lever on the bottom of the vehicle until the vehicle travels in a straight line

ADDING WATER TO THE TANK

• Add clean lap water to the use the VAPOR (realistic smoke effect).
• Be careful to only put water in the vehicle’s tank and not to spill water on the vehicle as this may cause a short circuit.
• The smoke effect is water mist and is of no harm to the user.
  

CONTENTS

• 1 x VAPOR RACER Vehicle
• 1 x USB Charging Cable
• 1 x Remote Control
• Water Dropper (for adding water to VAPOR RACER)

Warning!
This product must be assembled and used under the direct supervision of an adult
This product contains small components that present a choking hazard if swallowed; this product is not suitable for children under 6 years of age.

Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not / installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

“This device complies with FCC radiation exposure limits set forth for general population(uncontrolled exposure).This device must not be collocated or operating in conjunction with any other antenna or transmitter.”
Decoration of Conformity Inserts :
“Hereby, Guang Dong Syma model drone Industrial co, ltd, declares that this drone is in compliance with the essential requirements and other relevant provisions of Directive 201 4/53/EU.”
A copy of the full DoC is attached.

Customer Support

SYMA MODEL AIRCRAFT INDUSTRIAL CO.LTD
Address: Intersection of Xingye Road No_ 2 (West side) and Xingye Road (North side), Laimei Industrial
Park, Chenghai District Shantou, Guangdong Province. China
Sales hotline : 0754-86980668, After-sales hotline: 0754-86395095
Fax 0754-86395098 Zip code 515800

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>