REVOLT Radio Controlled Vapor Racer Vehicle User Manual
- June 6, 2024
- REVOLT
Table of Contents
REVOLT Radio Controlled Vapor Racer Vehicle
2.4GHz Remote control
PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE.
The materials, specifications, parts and packaging mentioned in this manual
are for reference purposes only. We are not responsible for any changes made
to this printed material, nor are we able to inform customers of any updates
or changes.
Please refer to our website: R3VOLT.COM for the latest
information.
Important safety information
Thank you for buying this REVOLT item. To ensure that you operate the vehicle correctly, please read these instructions carefully before first use and store them in a safe place for future reference.
Safety information
- Keep the smaller-sized accessories out of the reach of children.
- Do not store batteries in a hot environment (e.g. near open flames or a heating device).
- Children must be supervised by an adult when operating the vehicle. The vehicle should always remain within the line of sight of the driver (or instructor).
- Do not recharge non-rechargeable batteries. When installing or changing the batteries, ensure that they are connected in the correct polarity. Do not mix old and new batteries or different types of batteries.
- Do not short circuit the battery terminals.
- If you do not plan to use the vehicle for at least 10 days, discharge the battery to 40%-50% (i.e. if the battery is fully charged, drive the vehicle for half of the total driving time). This helps to prolong the lifespan of the battery.
- You must only use the charging cable provided. Disconnect the charging cable from the vehicle before cleaning. Regularly inspect the charging cable’s wires, plug socket, outer casing and other accessories to ensure they are not damaged. If there are any signs of damage, discontinue use immediately until repaired.
- After use, ensure that the vehicle and remote control are switched off and remove the batteries in the remote control.
- The packaging and this manual contain important information and should be kept in a safe place for future reference.
Repair and maintenance
- Clean the product regularly with a clean, soft cloth.
- Avoid exposing the product to direct sunlight or heat.
- Do not submerge the product in water, as this may damage the electrical components.
About this product
Remote-controlled vehicle
| Weight | 488g |
|---|---|
| Dimensions | 32.5x16x10cm |
| Remote control range | 15-20m |
| Operating temperature | 0 to 40 °C |
| Battery | 3.7V 900mAh rechargeble battery (included) |
Remote control
| Operating frequency | 2.4 GHz |
|---|---|
| Operating temperature | 0 to 40 °C |
| Battery Requirements | 2xAA 1.5V batteries (not included) |
OPERATING INSTRUCTIONS
Pairing: Switch on the remote control, and then press the on/off switch on the vehicle. Wait until the LED indicator on the remote control stops flashing and stays constant. This indicates that pairing was successful.
Use 2x AA 1.5V non-rechargeable batteries (not included).
Calibration button: Adjust the lever on the bottom of the vehicle until the vehicle travels in a straight line
ADDING WATER TO THE TANK:
- Add clean tap water to the use the VAPOR (realistic smoke effect).
- Be careful to only put water in the vehicle’s tank and not to spill water on the vehicle as this may cause a short circuit.
CONTENTS
- 1 x VAPOR RACER
- 1 x USB Charging Cable
- 1 x Remote Control
- Water Bottle (for adding water to VAPOR RACER)
Warning!
- This product must be assembled and used under the direct supervision of an adult.
- This product contains small components that present a choking hazard if swallowed; this product is not suitable for children under 6 years of age.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the users authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not / installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
“This device complies with FCC radiation exposure limits set forth for general
population(uncontrolled exposure).This device must not be collocated or
operating in conjunction with any other antenna or transmitter.”
Decoration of Conformity Inserts：
“Hereby, GUANG DONG SYMA MODEL AIRCRAFT INDUSTRIAL CO., LTD declares
that this drone is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU.”
A copy of the full DoC is attached.
Operation Frequency: 2405MHz-2473MHz
EIRP :-0.872dBm(0.82mW)*(for EU)
GUANGDONG SYMA MODEL AIRCRAFT INDUSTRIAL CO., LTD
Address: NO.2 WEST XINGYE ROAD LAIMEI INDUSTRIAL AREA SHANGHAI SHANTOU
GUANGDONG CHINA
Sales hotline: 0754-86980668, After-sales hotline: 0754-86395095
Fax: 0754-86395098 Zipcode: 515800