AMP Lighting AHS-7006-X-B-BZ-R1 Low Voltage Landscape Lighting User Guide

: June 9, 2024
: AMP Lighting

Table of Contents

Important Safety Instructions
Package Contents
- Product Dimensions
Installation
Product Dimensions
Customer Service
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AMP Lighting AHS-7006-X-B-BZ-R1 Low Voltage Landscape Lighting User Guide

Important Safety Instructions

Read Before Installation

This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.

These instructions do not intend to cover all variations in installation, operation maintenance or mounting situations.

Make sure the power is turned OFF before installing or servicing this luminaire.
WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or more from pool, spa or fountain.
This luminaire is intended to be used only with a power supply (transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
Wiring connections must be made with UL listed wire connectors that are suitable for outdoor use.
Position the low voltage wire and wire connector so that it is located within 6 inches (15.2 cm) from a building structure, a luminaire or fitting.
The main low voltage cable is intended for shallow burial – less than 6 inches (152 mm).
If additional lengths of low voltage cable are required, please contact www.amplighting.com or call 1-813-978-3900.

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

Turn off/unplug and allow to cool before replacing lamp.
Lamp gets HOT quickly! Contact only switch/plug when turning on.
Do not touch the hot lens, guard or enclosure.
Keep lamp away from materials that may burn.
Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
Do not operate the luminaire fitting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS

Package Contents

(1) Fixture Body

Product Dimensions

Installation

Remove Lens
Remove the lens from the luminaire by loosening the lock screws.
Install Lamp
Insert lamp with the correct wattage and type marked on the fixture label and push firmly into place.
CAUTION: Do not exceed maximum wattage marked on luminaire label.
Install Lens
Install the lens back onto the luminaire and tighten with previously removed lock screws.
Install Fixture to Mounting Surface
Place the fixture body onto the desired location. Mark four points on the mounting surface using the holes of the mount as a guide. Set the fixture aside and drill the proper holes where you placed the marks then insert the wall anchors into the drilled holes. Place the fixture onto the surface and secure with screws using a screwdriver.
Wire Connection
Strip both leads from the luminaire pigtail. Using two wire connectors (sold separately), connect the leads from the luminaire to the main supply cable leads.
Adjust Luminaire Direction
Using an Allen Key, loosen the set screws on the side of the fixture to rotate the luminaire to your desired direction by hand. Once you have the desired angle, tighten down the set screws with the Allen Key.