PROCHEM 7621 Safe and Effective Rust Spot Remover User Manual
- June 2, 2024
- PROCHEM
Table of Contents
PROCHEM 7621 Safe and Effective Rust Spot Remover
DANGER
-
Causes severe skin burns and eye damage.
-
Prevention: Do not breathe dust, fume, gas, mist, vapors, spray. Wash face and hands and any exposed skin thoroughly after handling.
-
Wear protective gloves, protective clothing, eye
protection, face protection. -
Response: If swallowed: Rinse mouth. Do NOT induce vomiting. If on skin (or hair): Take off immediately all contaminated clothing.
-
Rinse skin with water or shower. If inhaled: Remove person to fresh air and keep comfortable for breathing. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a poison center or
doctor. Wash contaminated clothing before reuse. -
If any condition(s) persist: Get medical advice/attention. More detailed First Aid measures may
be found in Section 4 of the SDS. -
Storage: Store locked up. Disposal: Dispose of contents in accordance with local/regional/national/interna- tional regulations.
-
11.6% of the mixture consists of ingredient(s) of unknown acute toxicity.
-
Contains: water (CAS 7732-18-5); oxalic acid (CAS 144-62-7); phosphoric acid (CAS 7664-38-2); 2-(2-butoxyethoxy)ethanol (CAS 112-34-5); urea hydrochloride (CAS 506-89-8); xanthan gum; trans-anethole; camphene; thymol; d-limonene; benzyl acetate; 3 phenyl-2-propenal READ SDS at LegendBrands.com
READ ALL INSTRUCTIONS AND PRECAUTIONS BEFORE USING INSTRUCTIONS
-
Ready to use, do not dilute. Shake gently before using. Pre-test on carpet or fabric for colorfastness, in an inconspicuous location.
-
Apply Prochem Rust Remover directly to the rust spot. Avoid over application. Allow 10-20 minutes of contact time. Agitate gently during dwell time with a brush or scraper (do not use fingers). Blot or extract area with clear water or cleaning solution.
-
Repeat steps 1-3 if necessary. Groom carpet or fabric to align fibers.
NOTE: Old or large rust spots will require longer contact time than recent rust spots. -
Gentle agitation speeds rust spot removal.
-
pH: 0.8 – 1.5 ready to use
CAUTION: Use product only in well-ventilated area. To avoid skin irritation or slip hazards, do not walk on wet carpets with bare feet.
NOTICE: Product must be stored at room temperature (59°F – 86°F/ 15°C – 30°C). -
Keep in sealed container when not in use.
-
Product is not warranted if used for repack, improperly stored, or used in a manner not consistent with manufacturer’s instructions.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>