EPOWP MC761 Aluminum Medicine Cabinet Instruction Manual
- June 2, 2024
- EPOWP
Table of Contents
Assemble Instruction
MC761 Aluminum Medicine Cabinet
Instruction Manual
MC761 Aluminum Medicine Cabinet
List of Parts:
Cabinet|
---|---
Top Bracket
Bottom Bracket
Side Mirror
Side Mirror Screw|
---|---
Wall Anchor
Mounting Screw
Tools Needed
Rough
Wall Opening
| Overall Size | 30 in.(W) X 26 in.(H) X 5 in.. (D) |
|---|---|
| Rough Wall Opening | 29-1/4 in(W) X 25-5/16 in. (H) X 3-7/8 in. (D) |
Use a 1/4 in. (6 mm) drill bit for drywall anchor installation. Use a 1/8 in.
(3mm)drill bit for direct stud installation.
NOTE: If installing into a material other than drywall or into stud,
consult professional for proper installation.
Step 1
Measure and mark two bottom mounting holes on the wall corresponding to the
pre-drilled hole locations in the bottom mounting bar.
Draw horizontal line connecting the two bottom marked location.the line should
to be level. adjust to level if necessary.
Use a 1/4 in. (6 mm) drill bit for drywall anchor installation. Use a 1/8 in.
(3mm) drill bit for direct stud installation.
NOTE: If installing into a material other than drywall or into stud,
consult a pro-fessional for proper installation.
RECESS
MOUNT INSTRUCTIONS
NOTE: Rough opening is not an exact measurement. The extra space allows
cabinet to be inserted into the opening. Add shims to level and tighten space
if necessary. Additional framing might be required.
STEP 1
NOTE: Before cutting the rough opening,check for pipes, electrical
cables, or heatingducts. If it is required to remove part of stud, make sure
that the wall is not a load bearing wall.
Prepare the opening in the wall for the cabinet body. Make sure that there is
support on both sides of the opening to attach the cabinet body , as shown.
NOTE: The cabinet height should be a minimum 2 in. above faucet.
STEP 2
Position the cabinet body in the rough wall opening. Make sure that the
cabinet body flange covers the wall opening uniformly.
Secure both sides of the cabinet body to the wall supports using mounting
screws .
NOTE: The cabinet body must be level for the door to work properly.
SHELF
ADJUSTMENT
For your convenience, adjustable shelves have been pre-installed. In order to adjust shelf location:
- Carefully slide the shelf out from shelf clips. See fig.1 .
- Loosen each shelf clip screw (two for each shelf) and slide to the desired location.See fig 2.
- Carefully slide the shelf into the shelf clips making sure shelf is level and retighten shelf clip screws.
HINGE ADJUSTMENT
SIDE-TO-SIDE:
Door is adjustable side to side by turning screw A clockwise or
counterclockwise.
UP-DOWN:
Loosen screw B on both top and bottom of hinge plate. Raise or lower door to
the desired position and re-tighten both screws.
IN-OUT:
Loosen screws C on both top and bottom hinges. Move the door in or out to
desired position and re-tighten.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>