EPOWP XYLBG-3224-O Large Oval Frameless Anti-Fog with LED Light Wall Mount Bathroom Vanity Mirror Installation Guide

: June 6, 2024
: EPOWP

Table of Contents

EPOWP XYLBG-3224-O Large Oval Frameless Anti-Fog with LED Light Wall
WARNING AND SAFETY INSTRUCTIONS
TOOLS REQUIRED
Read User Manual Online (PDF format)
Download This Manual (PDF format)

EPOWP XYLBG-3224-O Large Oval Frameless Anti-Fog with LED Light Wall

Mount Bathroom Vanity Mirror

WARNING AND SAFETY INSTRUCTIONS

Before assembling your LED Lighted Mirror fixture, please make sure that you carefully read through this instruction sheet, refer back to them during installation to ensure your product is fitted safely and correctly. Keep these instructions for future use.

WARNING Risk of Fire and Electric Shock

All fittings must be installed in accordance with current IEE wiring regulations. If in doubt, consult a qualified electrician.
Switch off the electrical supply at the main circuit board BEFORE installation and maintenance.
Suitable for indoor use only. This product should be positioned well away from curtains and fabrics. Never cover the mirror.
Regularly check the cord, the transformer and all other parts for damage. If any part is damaged the product should not be used.

INSTALLATION SAFETY

Inspect the product immediately upon receipt for the transit damage or missing parts. Handle the product with care and protect against knocks to all sides and edges of the glass.
Ensure there are no hidden pipes or cables in the wall before drilling.
Wear suitable eye protection when drilling. Take care if drilling on tiled surfaces in case the drill slips.

CAUTION: The light source of this product is non-changeable light diodes (LED). Do not disassemble the product, as the light diodes can cause damage to the eyes.

NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common
sense, caution and care, are factors that can’ t be built into any product. These factors must be supplied by the person(s) caring for and operating the fixture. Do not install this fixture in hazardous
locations.

TOOLS REQUIRED

tools required

HARDWARE LIST

Step1: Use the tape measure the height, and draw the horizontal line and the vertical line of the wash basin.

step 1

Step 2: Measure the distance of the mirror hole, and mark the hole place on the wall.

step 2

Step 3: Drill and insert the Wall Anchor

step 3

Step 4: Drive in the screw cross the bottom support.

step 4

Step 5: Align the holes of the mirror with the screws and hang them to complete the installation.

Step 5

Step 11

We provide plug with mirrors.
Optional to cut the plug directly and connect to electrical wiring if using wall switch.

step 11

After power on, the button shows blue and it is in waiting state.

Click the button to make the light gradually dims
Click the button again and the light gradually brightens

botton 3 After power on, the button shows blue and it is in waiting state, lick to turn on the defogging function and the button turns white.
Click again to turn off the defogging function and the button turn to blue.