sentiotec PRO-C2 Sauna Control Unit PRO C User Manual

sentiotec PRO-C2 Sauna Control Unit PRO C

The new function ensures optimal door monitoring for remote control!

Optional accessories: Door sensor home SAB00103 / 1-052-723

Note the change in the above product manual under the following points:

Installing bench sensor (clamp red wires at STB)

Connecting safety device or NEW connecting door sensor

Starting up

Remote start release:

• As standard the function selection switch is in the OFF position. The remote star is operated using „Standby for remote control“.
• If you want to enable the remote start output for various devices (e.g. coin-operated unit, remote start system), set the function selection switch 4 in the ON position

Settings in the technician menu

Activate door sensor

1. Open the technician menu (press the lower bottom knob and th e ON/OFF switch at the same time)

2. Activate the door-function If the remote start enable is switched ON, the door sensor must be activated. To do this, carry out
   the following steps:

   • Turn the top knob to the remote start symbol
   • The remote start symbol flash
   • In the top display „SdO“ appears
   • In the bottom display „SAFE“ appears (= Standard setting)
   • Turn the lower knob to the right
   • In the lower display “door“ appears

3. Exiting the technician menu (Longpress on the lower knob)

Operation

Activating „Standby for remote operation“ with door sensor

1. Turn the top knob to the remote start symbol
   • In the lower display „oFF“ appears
   • The remote start symbol flash.
2. Press the lower knob
   • A countdown of 30 seconds is shown in the lower display. During this time, the door can be opened/ closed as often as you like. After the countdown has expired, the door must be closed!
   • In the lower display „rc“ appears
   • The sauna control is now ready to be started and stopped once via a remote start signal = Mode „Standby for remote operation“

Door is opened – warning „door“ appears in the display

• at mode „Standby for remote operation“:
  To continue the mode, the door must be closed and the lower button has to be press two times.

  • The countdown (30 sec.) is shown again in the lower display.

•  in operation or enable remot start output (for coinoperated unit or door sensor system): The acknowledgment takes place automatically when the door is closed.

User program

The settings in the user programs has been added with the function runtime (hours) . A runtime of 2 hours is stored in all preset user programs and can be changed as described under „Creating your own user programs“.

additional to PRO C3:
Setting option up to the set heating period limit – see starting up function selector switches 1 and 2 (standard setting 6 hours)

Settings in the technician menu

Setting the runtime of the post-drying program

1. Open the technician menu (press the lower bottom knob and th e ON/OFF switch at the same time)
2. Turn the top knob to the humidity symbol
   • The humidity symbol lights up.
   • In the top display „SIn“ appears.
   • In the bottom display „OFF“ appears
3. Press the lower buttom
   • In the top display„dry“ appears
   • In the bottom display „t60“ appears
4. Turn the lower buttom (Selection 0 – 60; 0 = post-drying progamm off , 60 = maximum runtime in minutes)
5. Exiting the technician menu (Longpress on the lower knob)

Supplement/change to the operating instructions:

PRO-C2 /1-015-448 , PRO-C3 /1-015-451 Version 12/21

Product manual you can find at: https://www.sentiotec.com/downloads or

References

• sentiotec / Downloads
• sentiotec / Downloads

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>