HOT WHeeLs HHX49-4B70-4 LB-I-S Quadcopter Instruction Manual

HOT WHeeLs HHX49-4B70-4 LB-I-S Quadcopter

CONSUMER INFORMATION

TIPS & HINTS

1. When your jetpack RC starts to lose power, it may lose functionality or performance. This means it’s time for a recharge. Your jetpack RC’s running time may change depending on flying style and flying environment.

2. Radio interference can make your jetpack RC fly poorly. Interference can be caused by other jetpack RC’s running on the same frequency, electrical wires, large buildings, CB radios, or other wireless gear. Try to stay away from these!

3. Point your remote controller up, and not down toward your jetpack RC. If your jetpack RC gets too far away, it won’t work properly.

4. Don’t store your jetpack RC near heat or in direct sunlight. Always turn switches OFF and remove all batteries before storage.

5. Don’t fly your jetpack RC in sand or through water or snow. Do not immerse in water. If jetpack RC and/or remote controller does get wet, wipe it with a towel, remove all batteries from the
   remote controller, and allow to dry completely overnight. Replace with fresh batteries before next use.

6. When exposed to an electrostatic source, the jetpack RC and/or remote controller may malfunction. To resume normal operation remove the batteries from the remote controller and reinstall them after 5 seconds and/or switch the jetpack RC off then back on again.

7. Play safely! Always fly indoors and do not fly the jetpack RC outside under rainy, windy, or other severe weather conditions.

SAFETY TIPS

• DO NOT pick up the jetpack RC while in motion.
• Keep fingers, hair, and loose clothing away from the propellers while the jetpack RC is switched ON.
• Adult supervision is recommended when this jetpack RC is being operated.
• To avoid accidental operation, remove all batteries from the remote controller and switch off the jetpack RC when not in use and before storage.
• Use only with a 5V/1000mAh USB charger.

BATTERY SAFETY INFORMATION

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (+ and –).
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.

Protect the environment by not disposing of this product or any batteries with household waste. This symbol indicates that this product shall not be treated as household waste. Check your local authority for recycling advice and facilities.

REPAIR & MAINTENANCE

• Use clear household tape to repair tears, creases, or cracks. Use sparingly as added weight will affect performance.
• Dirt or mud on the jetpack RC can affect its operation. Use a clean, dry cloth to remove any dirt immediately. If the jetpack RC gets wet, turn it off and allow it to dry completely overnight.

NOTE

• The jetpack RC may malfunction when it is exposed to an electrostatic source. To resume normal operation, turn the power OFF and ON again.

NOTE TO ADULTS

• To remove and dispose of the Li-ion rechargeable battery safely, turn off the jetpack RC, cut out the battery from the foam casing, and use scissors to cut the wires. Next, wrap the wire ends with tape to isolate the Li-ion battery and dispose of it in accordance with your local laws.

CAUTION

HARMFUL IF TOUCHED WHILE IN USE

• Never grab/touch the jetpack RC when the propellers are in motion.
• Stand back from the jetpack RC when operating.
• To prevent entanglement, keep all hair away from moving parts.
• Surfaces may become hot and cause burns if electronics get wet.
• Do not attempt to grab a rotating propeller.
• If the propeller(s) is/are damaged, do not fly the jetpack RC.
• Flying with damaged propellers may lead to injury.

FOR PRODUCT SOLD IN USA

This device complies with Part 15 of the FCC Rules

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

FOR PRODUCTS SOLD IN CANADA

This equipment complies with FCC & Canada radiation exposure limits set forth for uncontrolled environments. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Disney/Pixar www.disney.com

• 2022 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted.

INSTRUCTIONS

FOR INDOOR USE ONLY

Please keep these instructions for future reference as they contain important information.

IIMPORTANT

• Please read all instructions before operating your jetpack RC. Adult supervision is recommended when the jetpack RC is being operated.

CONTENTS

CAUTION

MISE EN GARDE

• SURFACES MAY BECOME HOT AND CAUSE BURNS IF ELECTRONICS GET WET.

FEATURES

• THROTTLE JOYSTICK (ASCENT/DESCENT/SPIN)
• STEERING JOYSTICK
• STEERING JOYSTICK
• STUNT
• POWER
• TAKEOFF
• LANDING
• BATTERY BOX
• POWER SWITCH
• CHARGE PORT
• LED INDICATOR

SET UP

BATTERY INSTALLATION

1. Unscrew the battery cover with a Phillips head screwdriver (not included).
2. Install 2 AAA (LR03) 1.5V alkaline batteries (not included) with polarity (+/-) as shown inside the battery compartment. For longer life, use alkaline batteries.
3. Replace battery cover and tighten screw.
4. Replace batteries in the remote controller if the LED on the remote controller does not go on during play or if the jetpack RC does not respond well after a recharge.

CHARGING THE JETPACK RC

The jetpack RC is powered by a permanently installed Lithium-ion (Li-ion) battery, and it must be fully charged before first use.

1. Slide the power switch to OFF (O/ ).
2. Connect one end of the charge cord to the jetpack RC’s charge port and plug the other end in to a 5V/1000 mAH USB charger (not included).
3. Charging will begin when the cord is connected. A LED on the jetpack RC will light up as it is charging.
4. The LED will go off when the jetpack RC is fully charged. Unplug the charge cord when charging is complete. A full charge will usually take approximately 90 minutes. Charging time may vary.
5. Recharge the jetpack RC when you hear the low battery warning.

NOTE: Power switch must be in the OFF (O/ ) position when charging the jetpack RC.

• LED on
• LED off
• Low battery

PAIRING THE REMOTE CONTROLLER AND JETPACK RC

1. Slide the power switch to ON (I) on the jetpack RC.
2. Press the remote controller’s power button after switching on the jetpack RC.
3. Pairing is complete when the LEDs change from flashing to solid on the jetpack RC and the remote controller.

NOTE: If the jetpack RC does not respond to the remote controller after pairing, switch the jetpack RC off then back on to try pairing again or replace the batteries in the remote controller if the batteries are drained.

ATTACHING THE FIGURE

• Attach figure to the jetpack RC!
• Not for use with some figures.

HOW TO FLY

CHECKLIST

• Is the jetpack RC fully charged?
• Is the remote controller equipped with fresh batteries?
• Is the remote controller paired with the jetpack RC?

CONTROLS

• TAKEOFF
• LAND
• ASCEND/DESCEND
• SPIN
• FORWARD/BACKWARD
• SIDESLIP LEFT OR RIGHT
• STUNT

SKILL CHECK!

• Remember, steering directions are flipped on the remote controller when you are flying backward.

NOTE:

• The jetpack RC will automatically land if the battery power runs close to empty.

References

• Disney.com | The official home for all things Disney
• Les Jouets Mattel France - Bienvenue sur Les Jouets Mattel
• MATTEL & FISHER-PRICE CUSTOMER SERVICE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>