Hot WHeeLs HCC81 Supercharged Shark Vehicle Instructions

Hot WHeeLs HCC81 Supercharged Shark Vehicle

OUTDOOR USE RECOMMENDED

Keep these instructions for future reference as they contain important information. IMPORTANT: Please read all instructions before operating your vehicle.

CAUTION:

Surfaces may become hot and cause burns if electronics get wet. To prevent entanglement, keep all hair away from moving parts.

Adult supervision is recommended when the vehicle is being operated.

CONTENTS

FEATURES

CHARGING THE VEHICLE

The vehicle is powered by a permanently installed Lithium-ion (Li-ion) battery, and it must be fully charged with the included USB cable before first use.

1. Switch off the vehicle before each charge.
   

2. Open the charge port door and cover.
   

3. Connect the included USB cable to the vehicle’s USB port and a 5V/1000 mAH USB charger (not included). A red LED will light up on the power button to indicate the vehicle’s battery is charging.
   

4. The red LED will turn green when the battery is fully charged. A full charge will take around 2 hours (charging time may vary).
   

5. Disconnect the USB cable and close the port cover and door.
   

6. When the red LED is rapidly flashing on the remote controller, your vehicle is low on battery and requires a recharge.
   

Battery is charging

Low battery

Battery fully charged

TIP: The battery will be hot after play. Wait at least 10 to 15 minutes until the battery cools down before recharging the vehicle.

SET UP

REMOTE CONTROLLER BATTERY INSTALLATION

1. Unscrew the battery cover with a Phillips head screwdriver (not included).
2. Install 4 AA (LR6) 1.5V alkaline batteries (not included) with polarity (+/-) as shown inside the battery compartment. For longer life, use alkaline batteries.
3. Replace battery cover and tighten screw.
4. Replace batteries in the remote controller if the vehicle does not respond well.
   

PAIRING THE REMOTE CONTROLLER AND VEHICLE

1. Press the vehicle’s power button
   

2. Press the remote controller’s pairing button
   

3. Pairing is complete when the lights change from flashing green to solid green on the remote controller and the vehicle.
   

Pairing

Pairing is complete

NOTE: Pairing is unsuccessful if the LED indicators on the vehicle and remote controller are rapidly flashing green. Switch off the vehicle, then press and hold the pairing button to switch off the remote controller and try pairing again.

STEERING ALIGNMENT

1. Check the vehicle’s steering alignment before playing by driving it forward to see if it is driving straight.
2. If the vehicle automatically steers toward the right/left, press the alignment button in the opposite direction a few times until it runs in a straight line.
   

HOW TO DRIVE

DRIVE ON LAND AND WATER!
OPERATING RANGE: 30 m (100 ft) ON LAND; 15 m (50 ft) ON WATER

CHECKLIST

• Is the charge port door closed properly?
• Is the USB port covered?
• Are the batteries fully charged?
• Is the remote controller paired with the vehicle?

CONTROLS

The controls are the same on land and on water. Drive on land, and then drive straight into water and keep going!

√ SKILL CHECK!

Remember, turning directions are flipped on the remote controller when you are driving backward!

UPSIDE DOWN DRIVING

Your vehicle can “swim” upside down when it’s in water! Turn your vehicle over when it is on water and keep driving!

TIPS

• Only drive the vehicle in shallow pools and ponds.
• Stay within the vehicle’s operating range. When the vehicle goes beyond the operating range, the remote controller will begin flashing green, and you will slowly lose control. Drive the vehicle back within the operating range or move closer until the remote controller LED returns to solid green.
• The operating range is shortened when driving upside down on water.

Outside operating range

Within operating range

HOW TO DRIVE

CHOMPING ACTION

Press the chomp button as you drive and see the vehicle chomp on both land and water!

TIPS & HINTS – FOR ALL DRIVING ENVIRONMENTS 

1. When your vehicle starts to lose power, it may lose functions or performance. It’s time for a recharge. For best stunt performance, always start with a fully-charged battery. Your vehicle’s running time may change depending on driving style and driving environment.
2. Radio interference can make your vehicle run badly. Interference can be caused by other RC vehicles running on the same frequency, electrical wires, large buildings, CB radios, or other wireless gear. Try to stay away from these!
3. Point your remote controller up, and not down toward your vehicle. If your vehicle gets too far away, it won’t work properly.
4. Don’t store your vehicle near heat or in direct sunlight. Always turn switches OFF and remove all batteries from remote controller before storage.
5. After each use, remove any water, moisture, dirt, or mud from the vehicle with a clean, dry cloth. Make sure the vehicle is fully drained of water and allow the vehicle to air-dry completely after use.
6. When exposed to an electrostatic source, the remote controller and/or the vehicle may malfunction. To resume normal operation of the remote controller, remove the batteries and reinstall them after 5 seconds. To resume normal operation of the vehicle, turn the power OFF for a few seconds, then turn it ON again.
   

TIPS & HINTS

PRO DRIVING TIPS

• When driving on grass surfaces, avoid tall grass patches as they might tangle the wheels.
• When driving in snow, turning performance may vary depending on the depth and wetness of the snow. For the best results, you may want to turn your vehicle by tapping or pulsing the remote controller controls.
• Your vehicle is engineered to drive right from one kind of terrain to another. Of course, it may not be able to do that if the transition from one surface to another is too steep or difficult. In that situation, simply pick up the vehicle and reposition it.

TIPS & HINTS

1. Operate your vehicle only in calm, clear water. Shallow ends of swimming pools and shallow ponds are recommended. Avoid deep water.
2. After a few minutes of water operation, make sure the vehicle is still close to the water’s edge. That way, your vehicle will be able to return safely using its own power.
3. Do not expose the remote controller to water. If the remote controller is accidentally exposed to water, remove the batteries and allow the remote controller to air-dry completely. Replace with fresh batteries before playing again.
4. Beware of swimmers and don’t get too close to the water’s edge when operating the vehicle.

SAFETY TIPS

• Play safely! Do not drive the vehicle in the street!
• DO NOT pick up the vehicle while in motion.
• Keep fingers, hair, and loose clothing away from the wheels while the vehicle is switched ON.
• Adult supervision is recommended when this vehicle is being operated.
• To avoid accidental operation, remove all batteries from the remote controller when not in use and switch the vehicle OFF before storage.

RECHARGEABLE BATTERY SAFETY INFORMATION

• Rechargeable batteries are only to be charged under adult supervision.
• Do not recharge battery if it is hot. Allow it to cool before recharging.
• Do not recharge a battery pack that shows leakage or corrosion.
• Do not disassemble the battery pack. The battery pack is a sealed rechargeable Li-ion battery pack.
• If the battery pack and/or charging port are wet, thoroughly dry before charging.
• Do not recharge non-rechargeable batteries.
• The Li-ion battery in the vehicle is not intended to be replaced or removed by consumers. Before disposal in the waste stream, the Li-ion battery must be removed by a qualified professional and disposed of separately according to local regulations on battery collection and recycling.
• Do not dispose of the batteries in a fire.

BATTERY SAFETY INFORMATION

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (+ and –).
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery (ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.

Protect the environment by not disposing of this product or any batteries with household waste. This symbol indicates that this product shall not be treated as household waste. Check your local authority for recycling advice and facilities.

FCC STATEMENTS

FOR PRODUCT SOLD IN USA

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

FOR PRODUCT SOLD IN CANADA

This equipment complies with FCC & Canada radiation exposure limits set forth for uncontrolled environments.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

For Remote: 1.29dBm (1.35mW) & For Shark: 4.85dBm(3.05mW)

HOT WHEELS RC SUPERCHARGED SHARK™      Marca: Mattel

©2021 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted. ® et ™ désignent des marques de Mattel aux États-Unis, sauf indication contraire. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A.
Consumer Services 1-800-524-8697. Mattel Canada Inc., Mississauga, Ontario L5R 3W2. You may call us free at / Composez sans frais le 1-800-524-8697. Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland. Mattel
U.K. Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK. Mattel Australia Pty. Ltd., 658 Church St., Richmond, Victoria, 3121. Consumer Advisory Service – 1300 135 312. Mattel East Asia Ltd., Room 503-09, North

References

• Les Jouets Mattel France - Bienvenue sur Les Jouets Mattel
• MATTEL & FISHER-PRICE CUSTOMER SERVICE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>