Hot WHeeLs HLT20-MA70 Toyota Supra RC Car Instructions

INSTRUCTIONS
+5

OFFICIAL LICENSED PRODUCT

Porsche, the Porsche shield and the distinctive design of Porsche cars are
trademarks and trade dress of Porsche AG. Permission granted.

HOTWHEELS.COM

HLT20-MA70 Toyota Supra RC Car

©2022 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted. ® et ™

Keep these instructions for future reference as they contain important information.
IMPORTANT: Please read all instructions before operating your vehicle

HVIN: HLT20R ( ), HLT20T ( )

Operating Frequency: 2420-2462MHz

Maximum radio frequency power transmitted: **: -21.38 dBm(0.01mW), : -0.99 dBm(0.8mW)**

CONTENTS

FEATURES

A CHARGE PORT
B POWER SWITCH
C,D LED INDICATOR
E BOOST BUTTON
F DRIVING CONTROLS
G PAIRING BUTT
H ALIGNMENT BUTTONS

SET UP

A. REMOTE CONTROLLER BATTERY INSTALLATION

1. Unscrew the battery cover with a Phillips head screwdriver (not included).
2. Install 2 AA (LR6) 1.5V alkaline batteries (not included) with polarity (+/-) as shown  inside the battery compartment. For longer life, use alkaline batteries.
3. Replace battery cover and tighten screw.
4. Replace batteries in the remote controller if the LED on the remote controller does not go on or if the vehicle does not respond well after a recharge.

B. CHARGING THE VEHICLE
The vehicle is powered by a permanently installed Lithium-ion (Li-ion) battery, and it must be fully charged before first use.

1. Switch off the vehicle by sliding the power switch to OFF (O/ ).
2. Connect one end of the charge cord to the vehicle’s charge port and plug the other end in to a 5V/1A USB power adapter (not included).
3. Charging will begin when the cord is connected. A red LED on the vehicle will be on as the vehicle is charging.
4. The LED will turn green but remain on for a while when the vehicle is fully charged. Unplug the charge cord when charging is complete. A full charge will usually take  approximately 30 minutes. Charging time may vary.
5. Recharge the vehicle when it begins to respond slowly.
   NOTE: Power switch must be in the OFF (O/ ) position when charging the vehicle.

Red
Vehicle is charging

Green
Vehicle is fully charged

TIP: The battery will be hot after play. Wait at least 10 to 15 minutes until the battery cools down before recharging the vehicle.

C. PAIRING THE REMOTE CONTROLLER AND VEHICLE

• Slide the power switch to ON (I) on the vehicle.
• Press the pairing button on the remote controller after switching on the vehicle.
• Pairing is complete when the remote controller’s LED changes from flashing red to solid red.

NOTE:

• If the remote controller’s LED indicator does not stop flashing in approximately 10 seconds, switch off the vehicle, turn it back on, and then press the pairing button on the remote controller to try pairing again.
• The vehicle and remote controller will go into sleep mode if left idle for approximately 5 minutes. To resume normal play, slide the vehicle’s power switch to OFF then ON, and then pair the vehicle and remote controller again by pressing the remote controller’s pairing button until the LED lights up.

Pairing
Pairing is complete

D. STEERING ALIGNMENT

1. Check the vehicle’s steering alignment before playing by driving it forward to see if it is driving straight.
2. If the vehicle automatically steers toward the right/left, press the alignment button in the opposite direction a few times until it runs in a straight line.

HOW TO DRIVE

CHECKLIST

• Is the vehicle fully charged?
• Is the remote controller equipped with fresh batteries?
• Is the remote controller paired with the vehicle?

CONTROLS

SKILL CHECK!

Remember, steering directions are flipped on the remote controller when you are driving backward!

RACE ON TRACK AND OFF TRACK!

NOTE: Operating range of the remote controller is up to 20 m (65 ft).

SPEED BOOST
Press the boost button for extra speed!

MORE WAYS TO PLAY

WORKS WITH

Race on and off various Hot Wheels® tracks and sets for a new challenge!

NOTE: Avoid driving through launchers and boosters as they may damage the vehicle.
Tracks and sets not included. Sold separately, subject to availability.
The Li-ion battery in the vehicle is not intended to be replaced or removed by consumers. Before disposal in the waste stream, the Li-ion battery must be removed by a qualified professional and disposed of separately according to local regulations on battery collection and recycling.

CONSUMER INFORMATION

Keep these instructions for future reference as they contain important information.
IMPORTANT: Please read all instructions before operating your vehicle.

ATTENTION

CAUTION:
Surfaces may become hot and cause burns if electronics get wet. To prevent entanglement, keep all hair away from moving parts.
Adult supervision is recommended when the vehicle is being operated.
The toy is only to be connected to Class II equipment bearing the symbol

Protect the environment by not disposing of this product or any batteries with household waste. This symbol indicates that this product shall not be treated as household waste. Check your local authority for recycling advice and facilities.

TIPS & HINTS – FOR ALL DRIVING ENVIRONMENTS

1. When your vehicle starts to lose power, it may lose functionality or performance. It’s time for a recharge/fresh batteries. For best performance, always start with a fully-charge/fresh battery. Your vehicle’s running time may change depending on driving style and driving environment.
2. Radio interference can make your vehicle run poorly. Interference can be caused by other RC vehicles running on the same frequency, electrical wires, large buildings, CB radios, or other wireless gear. Try to stay away from these!
3. Point your remote controller up, and not down toward your vehicle. If your vehicle gets too far away, it won’t work properly.
4. Don’t store your vehicle near heat or in direct sunlight. Always turn switches OFF and remove all batteries from remote controller before storage.
5. Don’t drive your vehicle in sand or through water or snow. Do not immerse in water. If your vehicle does get wet, wipe it with a towel and allow to dry completely overnight. If your remote controller is accidentally dropped in water, remove battery(ies) and allow your remote controller to air dry. Replace with fresh battery(ies) before operation.
6. When exposed to an electrostatic source, the remote controller and/or the vehicle may malfunction. To resume normal operation of the remote controller, remove the batteries and reinstall them after 5 seconds. To resume normal operation of the vehicle, turn the power OFF for 5 seconds, then turn it ON again.
7. Play safely! Do not drive the vehicle in the street!

SAFETY TIPS

• Play safely! Do not drive the vehicle in the street!
• DO NOT pick up the vehicle while in motion.
• Keep fingers, hair, and loose clothing away from the wheels while the vehicle is switched ON.
• Adult supervision is recommended when this vehicle is being operated.
• To avoid accidental operation, remove all batteries from the remote controller when not in use and switch the vehicle OFF before storage.

FOR PRODUCT SOLD IN USA

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

FOR PRODUCT SOLD IN CANADA

This equipment complies with FCC & Canada radiation exposure limits set forth for uncontrolled environments.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:
(1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

GENERAL BATTERY SAFETY INFORMATION

• Non-rechargeable batteries are not to be recharged.
• Do not dispose of the batteries in a fire. The batteries inside may explode or leak.
• Dispose of battery(ies) safely.

RECHARGEABLE BATTERY SAFETY INFORMATION – FOR PRODUCTS WITH RECHARGEABLE BATTERIES

• Rechargeable batteries are only to be charged under adult supervision.
• Do not recharge battery if it is hot. Allow it to cool before recharging.
• Do not recharge a battery pack that shows leakage or corrosion.
• Do not disassemble the battery pack. The battery pack is a sealed rechargeable Li-ion battery pack.
• If the battery pack and/or charging port are wet, thoroughly dry before charging.
• If the rechargeable batteries are removable, they are to be removed from the product before being charged.

BATTERY SAFETY INFORMATION – FOR PRODUCTS WITH NON-RECHARGEABLE DRY CELL BATTERIES

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (+ and –).
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.

©2022 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted.

References

• Les Jouets Mattel France - Bienvenue sur Les Jouets Mattel
• Orbico Portal
• MATTEL & FISHER-PRICE CUSTOMER SERVICE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>