Hills 80150746 Line Rotary Clothesline Owner’s Manual

Hills 80150746 Line Rotary Clothesline Owner’s Manual

Introduction

Congratulations
Congratulations on the purchase of your new Hills Rotary Clothesline which will bring you many years of trouble free and efficient drying.
It is important that you read this Owner’s Manual thoroughly before installation and use. In this way you will benefit from all the design features and enjoy safe use of the product. Thank you for choosing Hills.

Warning

• Do not allow children or pets to swing on the clothesline or items of laundry.
• Ensure when raising and lowering your clothesline that bystanders(in particular children) are standing well clear.
• Do not use for any purpose other than to hang and dry washing.
• Do not use your clothesline if parts are worn or damaged.
• Do not allow the frame to lower in an uncontrolled manner as this may result in damage or injury
• Get the most out of your Hills product with our additional accessories sold separately.
  

Carton contents

Installation

Select a suitable location and install the ground socket
1.1 Select a suitable location which allows at least 0.5m clearance around the Rotary head assembly. (Figure 1)

Install the ground socket

WARNING: Do not push the ground socket into setting concrete. It’s important to follow the instructions and pour wet concrete around the ground socket.

2. 1 Dig a hole 250mm (7 0″) diameter by approximately 650mm (26″) deep. Place approximately 230mm (8″) of coarse gravel into the hole.
This ensures water can drain from the ground socket. (Figure 2)

2.2 Slide the locking collar onto the main pole. Push the index locking pin through the hole at the bottom of the main pole. Attach a small O-ring either side of
the pin holding it tight against the main pole. (Figure 3)

2.4 Place the ground socket and main pole into the hole. Push the base of the ground socket into the gravel. Ensure there is approximately 40mm of the ground socket buried into the gravel. Ensure the top of the ground socket sits approximately 1 0mm above the ground level. (Figure 4

2.5 Support the main pole into position and pour concrete mix around the ground socket. Check the main pole is vertical with a spirit level. Ensure the concrete finishes below the locking collar flange and pole. Taper away from the top flange so rain water runs away from the ground socket.
2.6 Leave the main pole in the ground socket until the concrete has set. Allow 24 hours for the concrete to set before final assembly. (Figure 5)

Assemble the hoist

Note:
Once the head assembly is locked into the main pole, it cannot be removed
Gently lower the head assembly into the main pole. Then to lock into position,raise the head assembly slightly and drop it down with light fo rce. You will hear a clicking noise, which means it is locked into position (Figure 6 – Part A)
To confirm it is locked, lift the head assembly upward and it sh ould no longer be able to lift out (Figure 6 – Part B).

3.3 If you wish to adjust the height of your rotary clothesline from the ground, remove the clothesline from the ground socket, and insert the spacers to
the desired height. (Figure 7) •

Hills Warranty

AMES Australasia Pty Ltd warrants that this Hills product will be free from defects in manufacturing of the frame and lifting mechanisms for the lifetime of the original purchaser of the product. This warranty does not extend to plastic hanging line or the surface finish of the product from weathering. If a defect covered by this warranty becomes evident during that period, AMES Australasia Pty Ltd will, at its option, replace the product, supply replacement parts for the product or refund the product.
The cost or labour required to install any replacement part or product supplied under a valid warranty claim is not covered.
In the event of a defect covered by this warranty, you should contact the Hills Customer Service Centre using the details below. You will require proof of purchase. Any expenses incurred in making a claim under this warranty are not covered by the warranty.
This warranty does not apply to any defect or damage caused by accident, improper use, abuse, neglect, or unauthorised alteration or repair. This warranty does not apply where the product was not installed in accordance with the product installation instructions. This warranty does not apply to any costs incurred in the installation of the product.

For products purchased in Australia

Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

For products purchased in New Zealand

Our goods come with guarantees that cannot be excluded under the
Consumer Guarantees Act. AMES Australasia Pty Ltd will comply with our obligations to you under the Consumer Guarantees Act.

Introduction

Congratulations
Congratulations on the purchase of your new Hills Rotary Clothesline which will bring you many years of trouble free and efficient drying.
It is important that you read this Owner’s Manual thoroughly before installation and use. In this way you will benefit from all the design features and enjoy safe use of the product. Thank you for choosing Hills.

Warning

• Do not allow children or pets to swing on the clothesline or items of laundry.
•  Ensure when raising and lowering your clothesline that bystanders (in particular children) are standing well clear.
•  Do not use for any purpose other than to hang and dry washing.
• Do not use your clothesline if parts are worn or damaged.
• Do not allow the frame to lower in an uncontrolled manner as this may result in damage or injury.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>