OLIGHT Swivel pro Rechargeable Work Torch User Manual
- June 3, 2024
- OLIGHT
Table of Contents
OLIGHT Swivel pro Rechargeable Work Torch User Manual
PRODUCT OVERVIEW
BATTERY LEVEL INDICATOR
4 blue lights on 75%-100%
3 blue lights on 50%-75%
2 blue lights on 25%-50%
1 blue light on 5%-25%
1 blue light strobe <5%
CHARGING
<25%, 1 blue light strobe
25%-50%, 1 blue light on, the second one strobe
50%-75%, 2 blue lights on, the third one strobe
75%-100%, 3 blue lights on, the fourth one strobe
100%, 4 blue lights on
- Before first use please fully charge the product.
- Connect the USB end of the Type-C to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a 5V 2A USB power source).
- Battery capacity: 5200mAh
- Time to fully charge: About 3.5 Hours
DANGER
- DO NOT throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
WARNING
- Don’t leave the light in a car where inside of temperature may be over 60℃，or in similar places.
- Before long term storage, please fully charge the product.
- When the charging port is not in use, keep the port dust cover closed to prevent the entry of dust or other foreign matters.
- Please DO NOT place the product in a dusty environment, because dust may enter the switch and cause it to malfunction.
- Do not disassemble the product.
- Do not immerse the light in seawater or other corrosive media as it will damage the product.
- Please handle it with care to protect it from falling down.
- O NOT pull its clip hook excessively to avoid damaging the product.
NOTICE
- Please charge the product with a 15W or higher-capacity USB power adapter to achieve the fastest charging possible.
- lease keep the product away from radios to avoid causing noise or interference to the radio signals.
EXCLUSION CLAUSE
Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual.
HOW TO OPERATE
ON/OFF: Press the button to turn on the light. Press the button again after
the light has been on for 3 seconds or more to turn it off.
CHANGE BRIGHTNESS: Press the button quickly to change brightness.
TWO MODES:
MODE 1(CAMP LIGHT MODE): Medium→High→Low→Red Light→Flashing Red Light→Off
MODE 2(FLASHLIGHT MODE): High→Low→Off
CHANGE MODES: While the light is on, press and hold the button for 1
second to exchange mode 1 and mode 2.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>