LIGHTOLIER IHB Series Decorative High Bay Instruction Manual

LIGHTOLIER IHB Series Decorative High Bay

LED High Bay Light Installation Instruction

Cautions:

1. Can not use the electric generator to test the LED light.
2. Please abide by related country, regional and local law and regulations when installing this fixture.
3. Please turn off the power before installation or maintenance.
4. Proper earth grounding is required to ensure safety.
5. This product is not suitable for cold storage areas where obvious temperature gradients are present, such as ventilation opening, door, etc.

Notice:

1. To avoid possibility of electrical shock or re, the installation personnel must have professional electric knowledge.
2. Please wear gloves to avoid injury before installation.
3. If any smoke or spark of the wire happened, please turn off the power immediately and notify relevant personnel.
4. For the top strain relief of power cord use standard 1/2″ MNTP non metallic connector or equivalent.

Attention:

1. Please check if there is any damage during shipping. If so, please contact manufacturer timely.
2. Please read the installation instruction carefully to check whether all the accessories are complete.
3. After con ration, then install the fixture according to installation steps.

As for the wire color of DIM+ and DIM-, pls check the light tabel

Installation Methods

Hook Mount, Ceiling Mount (Please choose the most suitable installation method for the purchased products as per your needs)

Hook Mount

1. Screw the hook into the fixture, tighten and fix it. figure 1)
2. Hang the fixture on the ceiling hook or chain. (figure 2)
3. After installation, connect the wire of the fixture to the mains according to local wiring rules, ensure the connection is stable and make good protection on the connection.

Ceiling Mount

1. Mark with a mark pen or sharp tool on the mounting surface and drill. (figure 3)

2. Fix screws into the holes with a hammer. (figure 4)

3. Align the bracket hole with screw hole (figure 5), and push the fixture to one side (figure 6) and fix it.

4. After installation, connect the wire of the fixture to the mains according to local wiring rules, ensure the connection is stable and make good protection on the brackets screws.

5. The bracket is not included in the box.

The fixture has an integrated function of selectable Power. The setting can be customized.
Operation: Take away the water-proof gasket, adjust dip switch to choose Power (Figure 8)

Put the shade over the Light module before mounting the light module to the ceiling

Figure 5 Bracket mount will work with the following.

| Medium| Large
---|---|---
Bell| Yes| Yes
Layers| Yes| Yes
Barn| No| No

© 2019 Signify Holding. All rights reserved. This document may be subject to change. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. All trademarks are owned by Signify Holding or their respective owners.

Signify North America Corporation
400 Crossing Blvd Suite 600,
Bridgewater Township, NJ 08807
Telephone: 732-563-3000

Signify Canada Ltd.
281 Hillmount Road,
Markham, ON, Canada L6C 253
Telephone: 905-927-4900
www.lightolier.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>