anlen E9X EU + UK Plug E-Scooter Owner’s Manual

anlen E9X EU + UK Plug E-Scooter

Product Information

Package Content

• Screw x 4
• Hexagon Wrench
• Charging adapter

Carefully check the package content. If anything is missing or damaged, please contact your local customer service for support.

Technical Data

• Dimensions (length / width / height)
• Weight
• Max. vehicle payload (rider + luggage)
• Max. speed
• Range (km)
• Applicable terrain
• Rated Voltage (VDC)
• Max charging voltage (VDC)
• Charging Rated current (A)
• Charging time
• Rated power (W)
• Max power

Product Overview

• Throttle
• Control panel
• Front light
• Brake lever with bell
• Folding mechanism
• Buckle
• Stoplight / Rear light
• Wheel motor
• Charging port
• Battery compartment
• Kickstand
• Disc brake

Assembly & Setup

1. Unfold the scooter and close & secure the folding mechanism.
2. Install the handlebar on the steering tube. Use the hex wrench supplied in the packing box to lock screws on both sides. Max. torque 5Nm.
3. Charger connection:
4. Open the rubber stopper
5. Insert the charging plug
6. After checking, close the rubber stopper

The Control Panel

• Mode indicator 1
• Speed display 2
• Battery indicator 3
• Power button 4

Low-speed modus (green light) High-speed modus (red light). Showing current speed while riding. When the low-speed mode is selected, the max speed is 12km/h. When high-speed mode is selected, the max speed is 20km/h.

There are four electric lights to indicate the charging condition of the battery:

• When 4 lights are on, the capacity is between 100% – 75%.
• When 3 lights are on, the capacity is between 74% – 50%.
• When 2 lights are on, the capacity is between 49% – 25%.
• When 1 light is on, the capacity is between 24% – 00%.
• When the light is flashing, the battery is almost empty. Please recharge as soon as possible.
• When the battery is empty, the four lights are off, and the scooter will slide to the natural stop by inertia, please recharge the scooter before using it.

Press the button 1x to activate the Scooter. When the scooter is activated, another short press will turn the light on / off. When the scooter is activated, double-click will switch from low-speed mode to high-speed mode. Press the button for 2 seconds to switch the scooter off.

How To Ride

1. Wear a helmet and knee pads while riding the Scooter.
2. Check the battery status and the brakes before each ride.
3. Step on the deck with one foot, and slowly kick off the other on the ground.
4. When the scooter starts to move, put both feet on the deck and press the accelerator (the accelerator initiates once the speed exceeds 5km/h).
5. Turn on the power and check the power indicator.
6. Release the throttle to stop acceleration. The energy recovery system automatically initiates to help slow down. Use the brake lever to stop.
7. Tilt your body to the steering direction as you turn.

Safety Reminder

When you use this vehicle for the first time, please ride it in a safe environment without obstacles or traffic. Please get familiar with the vehicle before you use it in public places. This electric scooter is a leisure device. But once used in a public area, they’ll be seen as vehicles, subjecting to any risks faced by vehicles. For your safety, please follow instructions in the manual and traffic laws and regulations set forth by government and regulatory agencies.

Package content

Carefully check the package content. If anything is missing or damaged, please contact your local customer service for support.

Technical data

Dimensions (length / width / height)| 10804301140mm unfolded/490mm folded
---|---
Weight| 12.7KG
Max. vehicle payload (rider + luggage)| 100KG
Max. speed| 20KM/H
Range (km)| 15-18KM (measured at 25°/15km/h/65kg payload)
Applicable terrain| Flat road
Rated Voltage (VDC)| 36V
Max charging voltage (VDC)| 42V
Charging Rated current (A)| 1.5A
Charging time| 5-6H
Rated power (W)| 250
Max power| 500W

Product Overview

Assembly & Setup

1. Unfold the scooter close & secure the folding mechanism.
2. Install the handlebar on the steering tube.
3. Use the hex wrench supplied in the packing box to lock screws on both sides.max. torque 5Nm

Charger connection

The control panel

Mode indicator| ****

1

| Low-speed modus (green light) High-speed modus (red light)
---|---|---
Speed display| ****

2

| Showing current speed while riding. When low speed mode is selected, the max speed is 12km/h. When high speed mode is selected, the max speed is 20km/h.
Battery indicator

3

| There are four electric lights to indicate the charging condition of the battery.

When 4 lights are on, the capacity is between 100% – 75%; When 3 lights are on, the capacity is between 74% – 50%. When 2 lights are on, the capacity is between 49% – 25%. When 1 light is on, the capacity is between 24% – 00%.

When the light is flashing, the battery is almost empty. Please

recharge as soon as possible.

When the battery is empty, the four lights are off, and the scooter will slide to the natural stop by inertia, please recharge the scooter before using.

Power button| ****

4

| Press the button 1x to activate the Scooter.

When the scooter is activated, another short press will turn the

light on / off.

When the scooter is activated, double-click will switch from low- speed mode to high-speed mode.

Press the button for 2 seconds to switch the scooter off.

How To Ride

• Wear a helmet and knee pads while riding the Scooter

• Check the battery status and the brakes before each ride.

• Step on the deck with one foot, and slowly kick off the other on the ground.

• When the scooter starts to move, put both feet on the deck and press the accelerator (the accelerator initiates once the speed exceeds 5km/h)
  Turn on the power and check the power indicator

• Release the throttle to stop acceleration. The energy recovery system automatically initiates to help slow down. Use the brake lever to stop.

• Tilt your body to the steering direction as you turn

Safety Reminder

• When you use this vehicle for the first time, please ride it in a safe environment without obstacles or traffic. Please get familiar with the vehicle before you use it in public places.
• This electric scooter is a leisure device. But once used in a public area, they‘ll be seen as vehicles, subjecting to any risks faced by vehicles. For your safety, please follow instructions in the manual and traffic laws and regulations set forth by government and regulatory agencies.
• At the same time, you should understand that risks cannot be entirely avoided as others may violate traffic regulations and drive incautiously, and you‘re exposed to road accidents just as when you‘re walking or cycling. The faster the scooter is, the longer it takes to stop. On a smooth surface, the scooter may slip, lose balance, and even result in a fall. Thus it is crucial that you use caution, keep proper speed and distance, especially so when you‘re unfamiliar with the place.
• Respect pedestrians right of way. Try not to startle them while driving, especially children. When you ride from behind pedestrians, ring your bell to give them a heads-up and slow your scooter to pass from their left (applicable to countries where vehicles drive on the right). When you ride across pedestrians, keep to the right at a low speed.
• Closely follow the safety instructions in the manual especially in countries without relevant laws and regulations for electric scooters.
• Do not lend your scooter to persons who don´t know how to use it.
• Check the scooter before every use. When you note loosen parts, low battery alerts, flat tires, excessive wear, strange sounds, malfunctions and other abnormal conditions, stop riding immediately and call for professional support.

Folding and Carrying

Make sure that the scooter‘s turned off . To fold, unlock the folding mechanism, and bend the handlebar stem to hook the buckle on the rear mudguard. To open, press the trigger to remove from the buckle, erect the handlebar and lock the folding structure.
Hold the handlebar stem with either one hand or both hands to carry.

Daily Care and Maintenance

Cleaning and storage

If you see stains on the scooter‘s body, wipe them off with a damp cloth. If the stains won‘t scrub off, put on some toothpaste, and brush them with a toothbrush, then wipe them off with a damp cloth. Notes: do not clean the scooter with alcohol, gasoline, kerosene or other corrosive and volatile chemical solvents. Do not wash the scooter with a pressure washer. During cleaning, make sure that the scooter is turned off, the charging cable is unplugged, and the rubber flap is closed as water leakage may result in electric shock or other major problems.
When the scooter is not in use, keep it indoors where it is dry and cool. Do not store it outdoor for long time. Excessive sunlight, overheating and overcooling accelerate tire aging and compromise the scooter and the battery pack‘s lifespan.

Battery maintenance

• Use original battery packs, use of other models or brands may cause safety issues;
• Do not touch the contacts. Do not dismantle or puncture the casing. Keep the contacts away from metal objects to prevent short circuit which may result in battery damage or even injuries and death.
• Use original power adapter to avoid potential damage or fire;
• Mishandling of used batteries may do tremendous harm to the environment. To protect natural environment, please follow local regulations to properly dispose used batteries.
• After every use, fully charge the battery to prolong its lifespan.
• Do not place the battery in an environment where the ambient temperature is higher than 50°C or lower than -20°C (e.g., do not leave the scooter or the battery pack in a car under direct sunlight for an extended time). Do not throw the battery pack into fire as it may lead to battery failure, battery overheating, and even another fire. If the scooter is expected to be left idle for more than 30 days, please fully charge the battery and place it in a dry and cool place. Keep in mind to recharge it every 60 days to protect the battery from potential damage which is beyond limited warranty.
• Always charge before exhausting the battery to prolong the battery‘s lifespan. The battery pack performs better at normal temperatures, and poor when it is below 0°C. For instance, when it is below -20°C, the riding range is only half or less at normal state. When the temperature rises, the riding range restores.

Adjusting the disc brake

If the brake is too tight, use the M4 hexagon wrench to loosen the screws on the caliper, and slightly send back the brake cable to shorten the exposed length, then tighten the screws. If the brake is too loose, loosen the screws, and slightly pull out the brake cable to lengthen the exposed length, then tighten the screws.

• Messingschlager GmbH & Co. KG hereby declares that the e-scooter Anlen E9X, item number 659905, is in compliance with the Directives 2014/35/EU; 2014/30/EU and 2011/65/EU(ROHS).
• The full text of the EU-Declaration of Conformity is available at: https://www.messingschlager.com
• If you have any questions or require more information about our products, please contact our customer service or send us an email.

Messingschlager GmbH & Co. KG, Haßbergstraße 45 96148 Baunach Germany
Tel: +49 (0)9544/944445
mail: kontakt@messingschlager.com
www.messingschlager.com

References

• Messingschlager GmbH & Co. KG - The Bike Experience
• Messingschlager GmbH & Co. KG - The Bike Experience

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>