AQUADECK welldana H-H-01 Corner Cover User Manual

June 3, 2024
AQUADECK

AQUADECK welldana H-H-01 Corner Cover

AQUADECK welldana H-H-01 Corner Cover

Corner cover

AQUADECK welldana H-H-01 Corner Cover-1

Corner cover with cable duct

AQUADECK welldana H-H-01 Corner Cover-2

Corner cover with Pre-assembled plates

AQUADECK welldana H-H-01 Corner Cover-3

Assembling the angles, brackets and the constuction

Corner cover

  • Corner cover with cable duct
    Mark the mounting holes according to drawing H-H-02 / H-H-03
    Drill the mounting holes (drill 11 mm)
    Mount the angles, suspension brackets with the gaskets (8x DIN933, 8x CI13.0840.1620, 8x Weco M8)
    Place the construction on the corner lines and secure it (2x DIN912, 2x DIN9021)
    Slide the tube over the suspension brackets and secure it (1x DIN912)

Corner cover with Pre-assembled plates

  • Find the holes according to drawing H-H-04 and pierce it
  • Mount the angles, suspension brackets with the gaskets (8x DIN912, 8x CI13.0840.1620)
  • Place the construction on the corner lines and secure it (2x DIN912, 2x DIN9021)
  • Slide the tube over the suspension brackets and secure it (1x DIN912)

Mounting the corner cap on the click system

  • Place the corner cover and click it on the click system (note position left, right and middle)
  • Before fitting the corner cover, stick the ribbons to the side of the bath and check the direction of rotation of the motor
  • When the cover is adjusted for the first time, attach a rope to the last slat to prevent too deep adjustment

Disassemble corner cover

Remove the corner cover of the click system by moving it from the bottom up

Pre-assembled plates

AQUADECK welldana H-H-01 Corner Cover-8

Pay attention:
Always use sealant when mounting the fasteners
Take more distance at round corners and skimmers entering the bath Minimal 30 mm)

Assembly of the Pre-assembled plates

concrete

  • Determine the motor side and drill a recess of 35 mm
  • Place the Pre-assembled plates in both corners and mark the 6 recessed holes (A)
  • Drill the 6 mounting holes with drill 11 mm (80 mm deep)
  • Insert the screws through the plates and then lightly tighten the weco plugs (12x DIN7991, 12x Weco M8)
  • Place the plates and carefully tap the screws with the weco into the wall with a hammer
  • Then tighten the screws well

styropole

  • Determine the motor side and drill a recess of 35 mm
  • Place the Pre-assembled plates in both corners and mark the 6 recessed holes (A)
  • Drill the 6 mounting holes with drill 11 mm (80 mm deep)
  • Insert the screws through the plates so that they end up in the hollow space of the styropole (12x DIN7991)
  • Install and tighten revet and hex nut (12x DIN9021, 12x DIN934)
  • Place the Weco and tighten it well so that it opens wide (12x Weco M8)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals