MeTra 70-7304 Receiver Wiring Adaptor Instruction Manual
- June 3, 2024
- Metra
Table of Contents
70-7304 Receiver Wiring Adaptor
Instruction Manual
IMPORTANT
Before starting, compare items on your invoice with items received. Thoroughly
check packing materials. If an item is missing, please call Crutchfield at
1-888-955-6000.
MATCH & CONNECT WIRES
A. Match wires below to the matching function of each wire on your receiver
(refer to instructions supplied with receiver). The wire colors of your new
receiver may, or may not, match the wire colors of the adaptor. Match adaptor
and receiver wires by function, disregarding color.
B. Your receiver illumination wire could be Orange or Orange/White. As with
other wires, match this wire to the illumination wire in this harness by
function, not by color. If your receiver does not have an illumination wire,
tape off the illumination wire.
C. Individually tape off any unused wires.
D. Make final wiring connections following instructions on the next
page.
CRIMP CONNECTIONS
Tools & Parts Required
A. Strip wires back 1/2”.
B. Twist wires together and insert in crimp cap.
C. Squeeze middle of cap for tight connection.
CONTINUED
D. Complete crimp connections for all necessary wires.
E. Be sure to wrap any wires from the Wiring Adaptor that are not necessary
(wires with no match from the new receiver) with electrical tape.
Generic Illustration
APPLICATION
When ready to install the receiver, plug the Wiring Adaptor from the new
receiver or receiver assembly into the factory radio harness(es) in the
vehicle dash.
Copyright 2017 Crutchfield Corporation
Documents / Resources
|
MeTra 70-7304 Receiver Wiring
Adaptor
[pdf] Instruction Manual
70-7304 Receiver Wiring Adaptor, 70-7304, Receiver Wiring Adaptor, Wiring
Adaptor, Adaptor
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>