Metra 95-6545B Radio User Manual
- May 15, 2024
- Metra
Table of Contents
95-6545B
INSTALLATION INSTRUCTIONS
Jeep Compass Sport 2017.5-2018
Visit MetraOnline.com for more detailed information about the product and up-
to-date vehicle specific applications
KIT FEATURES
• ISO DDIN radio provision
• Painted matte black
95-6545B Radio
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) (7) Panel clips
WIRING & ANTENNA CONNECTIONS (sold separately)
Wire harness: AXVI-6523
Antenna adapter: 40-EU10
Steering wheel control interface: AXSWC
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
Attention! Let the vehicle sit with the key out of the ignition for a few minutes before removing the factory radio. When testing the aftermarket equipment, ensure that all factory equipment is connected before cycling the key to ignition.
DASH DISASSEMBLY
- Unclip and remove the a/c ventpanel surrounding the radio. (Figure A)
- Remove (4)9/32”screws securing the radio, the nunplug and remove the radio. Continue to Kit Preparation
KIT PREPARATION
- Attach the (7) panel clips to the radio trim panel. (Figure A)
Continue to Kit Assembly
KIT ASSEMBLY
ISO DDIN radio provision
- Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A)
- Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/ OF AXxess.
- Test the radio for proper operation.
- Secure the radio assembly to the dash using the factory screws.
- Snap the radio trim panel over the radio assembly to complete the installation.
If you are having difficulties with the installation of this product, contact
our Tech Support line either by phone at 386-257-1187, or email at
techsupport@metra-autosound.com.
Before doing so, look over the instruction booklet a second time and ensure
that the installation was performed exactly as the instruction booklet is
stated. Have the vehicle apart and ready to perform troubleshooting steps
before contacting Metra/Axxess Tech Support.
KNOWLEDGE Is
POWER
Enhance your installation and fabrication skills by enrolling in the most
recognized and respected mobile electronics school in our industry. Log onto
www.installerinstitute.com or call
800-354-6782 for more information and take steps toward a better tomorrow.
Metra recommends
MECP certified technicians
Metra. The World’s Best Kits.®
MetraOnline.com
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
REV. 7/7/20 INST95-6545B
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>