RADEMACHER 2578 50 85 RolloTube S-line Zip DuoFern Instructions

RADEMACHER 2578 50 85 RolloTube S-line Zip DuoFern

DANGER!

• Risk of fatal electric shock when touching electrical components.
• The electrical connection of the tubular motor and all work on the electrical systems may only be undertaken by an authorised qualified electrician.
• Carry out all installation and connection work only in a de-energised state.
• Disconnect all phases of the mains power lead and secure it to prevent any reconnection.
• Check that the system is de-energised.
• There is also a risk of fatal injury from crushing resulting from uncontrolled starting of the drive.
• Never attempt to manually stop the screen in the event of uncontrolled movement.
• Before you begin, please read the detailed operating manual of the RolloTube S-line Zip DuoFern completely and follow all the safety instructions and installation instructions.

Preparation

Requirements for the correct execution of the following functions:

Self-learning operation:

• The screen requires a fixed end stop when raised in order to be able to learn the upper end point.
• The catch must be mounted with a freewheel mechanism.

Blockage detection:
The screen must move easily and freely.

Obstacle detection:
The catch must be mounted with a freewheel mechanism.

Electrical connection

Logging in

1. Switch on the mains power.
2. Tap the switch or button 2x and press and hold the third time until the tubular motor starts up briefly. Please refer to the operating manual of the DuoFern device or the log-on matrix in the service area on our website.

The RolloTube S-line Zip DuoFern tubular motors are self- learning motors at both end positions. This eliminates the need to set the end points or a teach- in run.

Self-learning commissioning

1. Switch on the mains power supply. The RolloTube S-line Zip DuoFern is ready for operation immediately.
2. First lower and then raise the screen. The end positions are automatically learned during the first run cycles.
3. Subsequently check the direction of travel if the RolloTube S-line Zip DuoFern is being operated using a switch or button. Switch the lines for the rotation direction if the direction of travel is wrong.

or setting end points manually

Initial installation

During the initial installation, the engineer can adjust the end points with a universal setting cable, available from a specialist retailer, see the operating manual of the RolloTube S-line Zip DuoFern.

Universal setting cable

Pin assignment:
The universal setting cable is connected with the same colours as the motor connecting cable of the RolloTube S-line Zip DuoFern, see above.

Button assignment:

• Button 1 = direction of travel (I / II)
• Button 2 = set button (III)
• Button 3 = continuous phase (ON/SET)

service.en@rademacher.de
Tel.: +49 2872 933 175

RADEMACHER
Geräte-Elektronik GmbH
Buschkamp 7
46414 Rhede (Germany)

Documents / Resources

| RADEMACHER 2578 50 85 RolloTube S-line Zip DuoFern [pdf] Instructions
2550 06 85, 2550 10 85, 2578 10 85, 2578 20 85, 2578 30 85, 2578 40 85, 2578 50 85, RolloTube S-line Zip DuoFern, 2578 50 85 RolloTube S-line Zip DuoFern, S-line Zip DuoFern, Zip DuoFern, DuoFern
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>