RADEMACHER 2360 50 75 RolloTube S-Line DuoFern Tubular Motors Instruction Manual

2360 50 75 RolloTube S-Line DuoFern Tubular Motors
Instruction Manual

2360 50 75 RolloTube S-Line DuoFern Tubular Motors

DANGER!
Risk of fatal electric shock when touching electrical components.

• The electrical connection of the tubular motor and all work on the electrical systems may only be undertaken by an authorised qualified electrician.
• Carry out all installation and connection work only in an isolated, de-energised state.
• Disconnect all phases of the mains power lead and secure it to prevent any reconnection.
• Check that the system is de-energised.

CAUTION!
Risk of crushing injuries to the hand when working with the roller shutter box open.
◆ Never reach into the area of the winding shaft when the motor is running.
Before you begin, please read this detailed operating manual of the RolloTube S-line DuoFern through completely and follow all the safety instructions and installation instructions.

Preparation

Requirements for the correct execution of the following function:
Self-learning operation:

• Stopper or end rail on the last slat.

• The driver adapter must be mounted with a freewheel mechanism.
  Ties and shaft connectors are both possible here.

• If the drive adapter is mounted without the freewheel mechanism, then rigid shaft connectors are required for installation of the roller shutter.
  Obstacle detection and fly screen door protection:

• The driver adapter must be mounted with a freewheel mechanism.
  Shutter length compensation:

• The upper end point must be learned automatically.

ATTENTION!
The roller shutter may run into the roller shutter box and be damaged without stoppers or end rails.
◆ Always fit two stoppers or an end-rail to the lowest slat of the roller shutter.

Electrical connection

Logging on
Briefly press the set button on the drive head until the tubular motor starts up briefly. You now have 120 seconds time to activate the log-on mode of a DuoFern device.
Please read the operating manual for the DuoFern device.
Self-learning commissioning
The RolloTube S-line DuoFern tubular motors are self-learning motors with a smooth stop at both end positions.
This eliminates the need to set the end points or a teach-in run.

1. Switch on the mains power supply. The RolloTube S-line DuoFern is ready for operation immediately.

2. Move the roller shutter up and down.
   The end positions for the smooth stop are automatically learned during the first drive cycles.

3. Subsequently check the direction of travel of the roller shutter, if the RolloTube S-line DuoFern is being operated using a switch or button. Switch the lines for the rotation direction if the direction of travel is wrong.

or setting end points manually

Initial installation

At the initial installation, the roller shutter engineer can carry out the end point setting with the help of the set button on the motor or with a commercially available universal setting cable, see operating manual of the RolloTube S-line DuoFern.

Universal setting cable

Pin assignment:
The universal setting cable is connected with the same colours as the motor connecting cable of the RolloTube S-line DuoFern, see above.
Button assignment:
Button 1 = direction of travel 1 /2
Button 2 = set button
Button 3 = continuous phase

service.en@rademacher.de
Tel.: +49 2872 933 175
RADEMACHER
Geräte-Elektronik GmbH
Buschkamp 7
46414 Rhede (Germany)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>