LANCOM 1800EF-5G High Availability Networking via 5G Fiber and Ethernet User Guide
- June 4, 2024
- LANCOM
Table of Contents
LANCOM 1800EF-5G High Availability Networking via 5G Fiber and Ethernet
introduction
-
5G antenna connectors
Screw the supplied mobile radio antennas to the appropriate connectors. -
Micro SIM card slot
Slide the SIM card into the SIM card slot using the marker to ensure that the card is the right way round. Ensure that the SIM card clicks into place on insertion.
To remove the card from the device, press the card lightly into the device. Let go to release the SIM card from the slot. -
Ethernet interfaces
Use the cable with the kiwi-colored connectors to con-nect one of the interfaces ETH 1 to ETH 4 to your PC or a LAN switch. -
WAN interface
Use the cable with the green connectors to connect the WAN interface to your WAN modem. -
SFP interface
Insert a suitable LANCOM SFP module (e.g. 1000Base-SX or 1000Base-LX) into the SFP port. Choose a cable compatible with the SFP module and connect it as described in the SFP module’s mounting instructions
www.lancom-systems.com/SFP-module-MI.
(SFP module and cable are not included) -
USB interface
Connect a USB data medium or a USB printer to the USB interface.
(cable not supplied) -
USB-C configuration interface
A USB-C cable is required to configure the device (cable not supplied) -
Power
After connecting the cable to the device, turn the bayonet connector 90° clockwise until it clicks into place.
Use only the supplied power adapter.
Before initial startup, please make sure to take notice of the information
regarding the intended use in the enclosed installation guide!
Operate the device only with a professionally installed power supply at a
nearby power socket that is freely accessible at all times.
Please observe the following when setting up the device
- The power plug of the device must be freely accessible.
- For devices to be operated on the desktop, please attach the adhesive rubber footpads
- Do not rest any objects on top of the device
- Keep all ventilation slots on the side of the device clear of obstruction
- In case of wall mounting, use the drilling template as supplied
- Rack installation with the optional LANCOM Rack Mount (separately available)
- Please note that support service for third-party accessories is excluded.
Mounting & connecting
