EMTEK Single-Point Lock Key in Knob/Lever Installation Guide
- June 3, 2024
- Emtek
Table of Contents
- EMTEK Single-Point Lock Key in Knob/Lever Installation
- Regoupillage du cylindre
- Rotate key counterclockwise 90º while pressing wire into hole.
- SLIDE LEVER KNOB OFF STEM
- After re-pinning cylinder, insert lever/knob onto stem
- Install Latch
- Remove Inside Trim Plate
- Unthread nut counterclockwise to remove from Interior Plate before
- Install Outside Trim Plate
- Install Inside Trim Plate
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
EMTEK Single-Point Lock Key in Knob/Lever Installation
Regoupillage du cylindre
STEP 1
Small hole should face down
Rotate key counterclockwise 90º while pressing wire into hole.
STEP 2
SLIDE LEVER KNOB OFF STEM
STEP 3
After re-pinning cylinder, insert lever/knob onto stem
STEP 4
Installation Guide Single-Point Lock, Key in Knob/Lever
Lock Assembly
Preparation
Install Strike Plate
Install Latch
Fasten Latch using two #8 x 3/4” Wood Screws (provided).
Remove Inside Trim Plate
Remove inside lever/knob by loosening set screw w/ hex wrench (provided).
STEP 1
Unthread nut counterclockwise to remove from Interior Plate before
installing on door.
STEP
Install Outside Trim Plate
Fasten Outside Trim Plate using two #8-32 x 1½” Pan Head Machine Screws
(provided).
Install Inside Trim Plate
Screw in flat head screw and threaded nut to secure Inside Trim Plate to door
STEP 1
Tighten set screw after placing lever/knob on stem.
Copyright © 2021, Emtek Products, Inc., an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part without the express written permission of Emtek Products, Inc. is prohibited.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>