EMTEK Key in Knob-Lever Lock Installation Guide
- June 3, 2024
- Emtek
Table of Contents
EMTEK Key in Knob-Lever Lock
Installation Instuctions
STEP 1
Small hole should face down
STEP 2
Rotate key counterclockwise 90º while pressing wire into hole
.
STEP 3
Slide knob/lever off stem
Copyright © 2021, Emtek Products, Inc., an ASSA ABLOY Group company. All
rights reserved. Reproduction in whole or in part without the express written
permission of Emtek Products, Inc. is prohibited.
WARNING : This product can expose you to chemicals including lead, which
is known to the state of California to cause cancer and birth defects or other
reproductive harm. For more information go to
www.P65Warnings.ca.gov.
STEP 4
After re-pinning cylinder, insert knob/lever onto stem
Key in Knob/Lever Lock Installation Guide
Experience a safer and more open world
Outside Tri **m
Inside Trim
**
Preparation
Door Prep
Install Strike Plate
Fasten Strike Plate using Two #8 x 3/4” Wood Screws (provided).
Install Latch
Fasten Latch using two #8 x 3/4” Wood Screws (provided).
Remove Inside Rosette
STEP 1
Remove inside knob/lever by loosening set screw w/ hex wrench (provided)
**STEP 2
Unthread rosette counterclockwise to remove from housing before installing on
door.
**
Installing Inside Chassis
Installing Inside Trim
STEP 1
Secure inside rosette to door by threading it clockwise on to stem.
STEP 2
Tighten set screw after placing knob/lever on stem
~~~~
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>