EMTEK Key in Knob/Lever Lock with 8 Style Rosette Installation Guide
- June 3, 2024
- Emtek
Table of Contents
- EMTEK Key in Knob/Lever Lock with 8 Style Rosette Installation
- Small hole should face down
- Rotate key counterclockwise 90º while pressing wire into hole.
- Slide knob/lever off stem.
- After re-pinning cylinder, insert knob/lever onto stem
- Install Latch
- Remove Inside Rosette
- Installing Inside Chassis
- Installing Inside Trim
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
EMTEK Key in Knob/Lever Lock with 8 Style Rosette Installation
Small hole should face down
STEP 1
Rotate key counterclockwise 90º while pressing wire into hole.
STEP 2
Slide knob/lever off stem.
STEP 3
After re-pinning cylinder, insert knob/lever onto stem
STEP 4
Key in Knob/Lever Lock with #8 Style Rosette Installation Guide
Lock Assembly
Preparation
Install Strike Plate
Install Latch
Fasten Latch using two #8 x 3/4” Wood Screws (provided).
Remove Inside Rosette
Remove inside knob/lever by loosening set screw w/ hex wrench (provided).
Unthread rosette nut counterclockwise to remove from housing before installing on door.
Installing Inside Chassis
Fasten Inside Chassis using two #8-32 x 1½” Pan Head Machine Screws (provided).
Installing Inside Trim
Secure inside rosette to door by threading nut clockwise on to stem.
Tighten set screw after placing knob/lever on stem. Copyright © 2021,
Emtek Products, Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of
Emtek Products, Inc. is prohibited.
WARNING: This product can expose you to chemicals including lead, which
is known to the state of California to cause cancer and birth defects or other
reproductive harm. For more information go to
www.P65Warnings.ca.gov.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>