EMTEK F20 UL Listed Mortise Lock Knob by Knob, Lever by Lever Installation Guide

June 3, 2024
Emtek

EMTEK F20 UL Listed Mortise Lock Knob by Knob, Lever by Lever

Installation Guide

  1. Install Cylinder Plug
    Install cylinder plug by threading it clockwise onto lock body

Note: Notch on cylinder plug must be in the 9 o’ clock position when fully screwed onto lock body.

  1. **Install Mortise Lock

See template for door prep specifications
**

  1. Adjust and Install Spindle
    Rotate one full turn until both slots are facing the same way.

  2. Install Key Cylinder
    Install key ¾ of the way into the key cylinder and thread it clock-wise onto trim plate.

Plates and lever/knob vary depending on style.

  1. Tighten Key Cylinder
    After key cylinder is installed, secure cylinder by tightening screw

EMTEK F20 UL Listed Mortise Lock Knob by Knob, Lever by Lever-
FIG6

  1. Mount Inside Trim to Door

EMTEK F20 UL Listed Mortise Lock Knob by Knob, Lever by Lever-
FIG7

  1. Install Trim Plate

  2. Tighten Inside Lever or Knob

Tighten both Levers with 3/32 Hex wrench (provided).

  1. Install Door Jamb

See template for door jamb prep specifications

Instructions to reverse swing

  1. Remove dowel screw. (Replace after reversing swing)
  2. Pull out and rotate latch bolt to reverse its direction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Emtek User Manuals

Related Manuals