EMTEK Two Point Lock Single Re-Pinning Cylinder Installation Guide
- June 3, 2024
- Emtek
Table of Contents
EMTEK Two Point Lock Single Re-Pinning Cylinder Installation Guide
Re-Pinning Cylinder (OPTIONAL)
-
STEP 1
Small hole should face down. -
STEP 2
Rotate key counterclockwise 90º while pressing wire into hole. -
STEP 3
Slide lever/knob off stem. -
STEP 4
After re-pinning cylinder, insert lever/knob onto stem.
Before inserting lever/knob onto stem, make sure cylinder tailpiece is vertical as shown.
Lock Assembly
Preparation
-
Install Bolt and Latch
Fasten Bolt and Latch using #8 x 3/4” Wood Screws (provided).
-
Remove Inside Trim Plate
STEP 1: Remove inside lever/knob by loosening set screw w/ hex wrench (provided).
STEP 2: Unthread nut counterclockwise to remove from Interior Plate before installing on door.
-
Install Outside Trim Plate
Fasten Outside Trim Plate using two #8-32 x 1½” Pan Head Machine Screws (provided).
-
Install Inside Trim Plate
STEP 1: Install deadbolt using flat head screws.
STEP 2: After interior grip is installed, tighten set screw with hex wrench (provided)
Copyright © 2021, Emtek Products, Inc., an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part without the express written permission of Emtek Products, Inc. is prohibited.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>