EMTEK Flat Track Sliding Barn Door Instruction Manual

June 3, 2024
Emtek

EMTEK Flat Track Sliding Barn Door

Flat Track Sliding Barn Door

General Info

  • The wall or structure that your system will be mounted on must be designed to support a  maximum door weight of 400 lbs.
  • Ensure that door panels are constructed with solid, structural material.
  • Do not install directly into drywall. Must be installed into wall blocking or header board.
  • Check with your contractor and/or your city of residence to confirm accordance with local building codes.
  • For best results, seek qualified building professionals for installation.

Tools Required

Tools Required

What’s in the box

  • Hangers
    What’s in the box

  • Stops

  • Floor Guide

  • Track Fasteners

  • Drywall Anti-crushes

  • Post & Spacers

  • Track
    What’s in the box

Splice Kit (Required for 10’, 13’ or 16’ Lengths)

  • Bracket

  • **Splice kit screws

**

Optional Soft Open/Close

  • Soft Open/Close C
    What’s in the box

  • **Catch

**

Installation Instruction

Mark for Track

Use the track as a template to mark the center of the holes.
Tracks with splice kits have a unique hole spacing between splice.
Installation Instruction Illustration
*Header board and anchor screws not included.

Installation Instruction Illustration
Install track splice (required for 10’, 13’, 16’ lengths)
Installation Instruction Illustration

Install Optional Soft Open/Close – Part 1

Mount the soft open/close on the bottom of the track and ensure that it is oriented in the correct direction for operation.
Installation Instruction Illustration

Secure Track

Drill 19/64” [7.54mm] pilot holes in marked locations for track fasteners.

Attach track to wall using track brackets and fasteners as shown.
Installation Instruction Illustration
Installation Instruction Illustration

Prep Door for Hangers & Floor Guide

Pre-drill 2-1/2” deep holes using a 11/64” bit as shown.
Installation Instruction Illustration
Route bottom, full length of door to receive floor mounted guide.
Installation Instruction Illustration

Mount Hangers to Door

Install screws using an Allen Wrench.
Installation Instruction Illustration

Hang the Door

Prior to hanging door on track rotate anti-jump toward front face of door to disengage.
Installation Instruction Illustration

Adjust the Stops

Tighten set screws. Start with bottom set screws then move to top set screws with sufficient force to drive set screws into bar after final adjustment. Ensure the stops allow for the door to extend the desired length over the door opening. Adjust stops accordingly.
Installation Instruction Illustration

Install Floor Guide

Drill pilot holes for anchors using 11/32” drill bit. Mount floor guide with anchors and screws provided.
Installation Instruction Illustration
Tip: Install floor guide in a position where it won’t be exposed with door in the open or closed position.

Install Optional Soft Open/Close – Part 2
  1. Move door to desired stop location.
  2. Place soft catch under soft open/close as shown.
  3. Mark location of soft catch.
  4. Remove door from track
  5. Install soft catch at marked location
  6. Hang door on track
    Installation Instruction Illustration

IN4-BARNTOPMNT
Copyright © 2021, EMTEK Products, Inc. an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part without the express written permission of EMTEK Products, Inc. is prohibited.

WARNING: This product can expose you to chemicals including lead, which is known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

EMTEK-Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Emtek User Manuals

Related Manuals