EMTEK S7010 Towel Bar Installation Guide
- June 3, 2024
- Emtek
Table of Contents
EMTEK S7010 Towel Bar
Installation
-
Locate Center of Mounting Plates
Make two marks on the wall to locate the center of the mouting plates. Center- to-center spacing for mounting plates is the same as the length of the towel bar.
-
Install Mounting Plates
Mark three hole locations for each mouting plate. -
Install Screw Anchors
Use a screwdriver to install three screw anchors into the wall for each mounting plate.
-
Install Mounting Plates
Secure mounting plates using the screws provided.
-
Install Trim Plates and Towel Bar
Slip Trim Plates and Tower Bar posts over the mounting plate studs.
-
Tighten Set Screw
Tighten the set screw at the base of the post with the Allen Wrench Provided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>