EATON CWGA-00-01 Battery Water Guard Detector Instruction Manual
- June 3, 2024
- EATON
Table of Contents
- EATON CWGA-00-01 Battery Water Guard Detector
- Battery Water Guard Detector
- CWGA-0x/xx SPECIFIFCATION
- COMPONENT
- Technical Data
- Mounting
- How to apply the sensor cable
- Remove sensor cable
- Basic mode
- LED during operation
- Quick User Guide
- Declaration of Conformity
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
EATON CWGA-00-01 Battery Water Guard Detector
Battery Water Guard Detector
CWGA-0x/xx SPECIFIFCATION
COMPONENT
Technical Data
- Power supply
- Battery CR2477N 3Vdc
- Battery service life up to 5 years (TYP, when no alarm)
- Alarm LED and Acoustic
- Push button Alarm acknowledge
- LED Multi-Color operation status
- Water sensor
- On device 2 contacts at the bottom
- External Flat-cable water sensor support
- Dimensions 51 x 46 x 18 mm (H x W x D)
- RF 868.3MHz (xComfort compatible)
- Max RF power 25 mW (ERP
Mounting
Warning! Device contains a small battery (< 32 mm) and should not be installed in a location likely to be accessible to children
External sensor (optional)
Connect sensor cable
How to apply the sensor cable
- Surface must be clean, dry and dust-free
- Do not to touch the exposed adhesive area at any time
- Press firmly
- Once mounted, the adhesive tape cannot be reused
Remove sensor cable
Basic mode
Connect Water Detector (Battery)
Remove Water Detector (Battery)
Back to factory Default
LED during operation
- Replace battery
- No RF communication
Quick User Guide
Declaration of Conformity
We, EATON Industries (Austria) GmbH
3943 Schrems, Eugenia 1 Austria declare under our sole responsibility as
manufacturer that the product (family)
Eaton – Battery Water Guard Detector CWGA-00/01
(the declaration of conformity applies to all listed types within our actual
product catalogue) provided that it is installed, maintained and used in the
application intended for, with respect to the relevant manufacturer’s
instructions, installation standards and “good engineering practices” complies
with the provisions of Council directive(s):
RED Directive 2014/53/EU
RoHS Directive 2011/65/EU + 2015/863 based on compliance with following
standard(s):
EN 300220-2 V3.2.1, EN 301 489-1 V2.2.3, EN 301489-3 V2.1.1, EN IEC
63044-5-1:2019, EN IEC 63044-5-2:2019, EN IEC 63044-5- 3:2019, EN IEC
62368-1:2020 + A11:2020, EN 63000:2018
Affixing date of CE mark: 2021
Doc.Id.: CWGA_00-01_111121
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria
MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217 ©
2021 by Eaton Industries (Austria) GmbH,
www.eaton.eu/documentation
www.eaton.com/recycling
All Rights Reserved / Printed in Austria
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>