EATON CJAE-01-01 Shutters-Blinds Actuator Instruction Manual
- June 3, 2024
- EATON
Table of Contents
EATON CJAE-01-01 Shutters-Blinds Actuator
Overview
Technical Data
- Power supply 230 VAC +10% -15%, 50 Hz
- Load 3 A, L/R
- Power standby < 230 mW (Typical)
- Protection Overload, Over-temperature
- Dimensions 27,5 x 32 x 125 mm (H x W x L)
- RF 868.3MHz (xComfort compatible)
- Max RF power 25 mW (ERP)
Wiring diagram
Basic mode
Assign Sensor in Basic Mode
Remove Sensor in Basic Mode
Not possible when assigned to xComfort Bridge
Configure application mode
Identify in MRF
Back to factory default
Declaration of Conformity
We, EATON Industries (Austria) GmbH 3943 Schrems, Eugenia 1 Austria
declare under our sole responsibility as a manufacturer that the product (family)
Eaton – Water Guard UP
CWGE-00/01
(the declaration of conformity applies to all listed types within our actual product catalogue) provided that it is installed, maintained, and used in the application intended for, with respect to the relevant manufacturer’s instructions, installation standards, and “good engineering practices”
complies with the provisions of Council directive(s):
- RED Directive 2014/53/EU
- RoHS Directive 2011/65/EU + 2015/863
based on compliance with the following standard(s):
EN 300220-2 V3.2.1, EN 301 489-1 V2.2.3, EN 301489-3 V2.1.1, EN
IEC 63044-5-1:2019, EN IEC 63044-5-2:2019, EN IEC 63044-5-
3:2019, EN 60669-2-5:2016, EN 63000:2018.
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation. www.eaton.com/recycling.
All Rights Reserved / Printed in Austria.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>