AQUABATOS GWR08 Shower Glass Wall Instruction Manual

AQUABATOS GWR08 Shower Glass Wall

Prior to installation please carefully examine the shower enclosure for transport or other damage. A thorough examination of all glass parts is essential for your own safety. Seemingly minor damage may cause breakage of glass and for this reason, extra care must be taken not to damage the glass edges of the shower enclosure during installation or use of the shower enclosure. Claims for transport damage after installation and claims for damage or cost caused by incorrect installation, cleaning and maintenance will not be paid. Personal protective equipment is recommended!

WARNING

Shower enclosures are intended for installation on shower trays. If installed without a shower tray, the floor on which the shower enclosure will rest must be flat and level. If installing on a joint or uneven surface, you must ensure this is properly siliconed to form a waterproof and maintenance-free seal. When assembled off-floor or with a step, you must take appropriate measures to prevent slip hazards on entry and exit. Before drilling the raw plug holes, the wall has to be tested for concealed service pipes (electricity-, gas- or water pipes). Drilling into these pipes is a life-threatening hazard as well as damage to property. Shower enclosures should be installed on solid walls and bases. If installing on non-solid walls and bases, you must ensure appropriate stability on site (e.g. by using special raw plugs). Please use adequate and correct silicone appropriate for the installation (e.g. for marble)

TOOL LIST

GWAS Walk in shower with angled stabilization bar

ASSEMBLY INSTRUCTIONS

1. 1x wall profile cover cap
2. 1x wall profile
3. 1x Fixed Plate
4. 1x Wedge Seal
5. 4x round head screw ST 4×30
6. 6x dowels
7. 2x pan head screw ST 4×30
8. 1x Stabilizer Bar

INSTALLATION INSTRUCTIONS

If you need help, we recommend that you contact a competent person Contact plumber.
Step 1

Step 2

Step 3

Danger:
The nano-coating can lead to that a suction cup is not on the glass pane liable. Please do not use suction cups around to raise the glass pane.

Step 4

Step 5

Silicone must dry for 24 hours before use. Silicone only on the outer edge.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>