AQUABATOS CPD04 CANNES Series Revolving Door Instruction Manual
- June 8, 2024
- AQUABATOS
Table of Contents
AQUABATOS CPD04 CANNES Series Revolving Door
Prior to installation please carefully examine shower enclosure for transport
or other damage. Thorough examination of all glass parts is essential for your
own safety. Seemingly minor damage may cause breakage of glass and for this
reason, extra care must be taken not to damage the glass edges of the shower
enclosure during installation or use of the shower enclosure. Claims for
transport damage after installation and claims for damage or cost caused by
incorrect installation, cleaning and maintenance will not be paid. Personal
protective equipment recommended !
Shower enclosures are intended for installation on shower trays. If installing
without a shower tray, the floor on which the shower enclosure will rest must
be flat and level. If installing on a joint or uneven surface, you must ensure
this is properly siliconed to form a waterproof and maintenance-free seal.
When assembled off-floor or with a step, you must take appropriate measures to
prevent slip hazards on entry and exit. Before drilling the raw plug holes,
the wall has to be tested for concealed service pipes (electricity-, gas- or
water pipes). Drilling into these pipes is a life threatening hazard as well
as damage to property. Shower enclosures should be installed on solid walls
and bases. If installing on non-solid walls and bases, you must ensure
appropriate stability on site (e.g. by using special raw plugs). Please use
adequate and correct silicone appropriate for the installation (e.g. for
marble)
TOOL LIST
DESCRIPTION
-
measuring tape
-
level
-
Pen
-
6mm drill
-
3mm drill
-
drilling machine
-
flathead screwdriver
-
Cross screwdriver
-
hammer
-
silicone syringe
CANNES revolving door for niche
INSTALLATION INSTRUCTIONS DRAWING
- 1x wall profile cover cap
- 1x wall profile A
- 6x dowels
- 6x round head screw ST 4×30
- 6x screw cover cap
- 6x round head screw ST 4×12
- 6x screw cap terminals
- 1x Movable Plate
- 1x handle
- 1x magnetic seal
- 1x magnetic profile
- 1x wood spacer
- 1x bottom seal
- 2x end cover L&R
- 1x drip tray
- 1x wall profile B
- 2x wall profile B cover cap L&R
- 1x magnetic profile cover cap
INSTALLATION GUIDE
If you need help, we recommend that you contact a competent person Contact plumber.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Silicone must dry for 24 hours before use. Silicone only on the outer edge.
Aqua Batos Baths Ltd Southwest parade 14 12161 Berlin
info@aquabatos.com
www.aquabatos.de
V01.09.2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>