PetSafe Seaside Stainless Steel Pet Fountain Instruction Manual
- June 3, 2024
- PetSafe
Table of Contents
PetSafe Seaside Stainless Steel Pet Fountain
Overview
Before we start
To keep providing fresh, clean water for your pet, remember these three simple tasks:
-
Refill often. Keep the water level up. The pump is designed to work in at least 3 centimetres of water. The pump can fail if it runs dry.
-
Clean your pump and your fountain. Take your pump and fountain apart to clean with soap and water every two to four weeks. Be careful not to get soap in the filters, as it will not rinse out. The plastic filter housing, stainless steel bowl and stainless steel tower
(except the silicone gasket) are dishwasher-safe. -
Replace your filters. Replace the carbon filter every two to four weeks when you clean your fountain. Replace the foam filter every one to two months.
- Remove the faceplate.
- Remove the stator.
- Remove the impeller.
Clean the pump before you assemble the fountain:
Wash these parts with soap and warm water, then put the pump back together.
Rinse all parts of the fountain in cold water except the cord and power
adaptor.
Install the foam filter and the pump
Insert the pump into the foam filter and set both down into the square inside
the bowl. Press down to attach the suction cups.
Feed the cord down into the tube and out between the feet on the bowl’s base
.
Insert the silicone cap and fold its top edge down over the top of the tube.
This holds the cord in place and prevents leaks.
Install the carbon filter and the tower: Rinse the carbon filter with cold
water, set it into the filter housing and close.
Insert the filter housing into the opening on top of the pump.
Set the tower down over the filter housing and press down on the silicone
gasket to form a seal. Connect the power adaptor.
Place the fountain where your pet will use it. Fill the bowl with water. Make sure the water level is at least to the MIN (minimum) fill line so the pump does not run dry. This will prime the pump for use. Do not fill the fountain past the MAX (maximum) fill line. Make sure your hands, the cord and the power adaptor are dry, then plug the fountain into an outlet. If your pet is hesitant to use the fountain at first, try leaving the fountain unplugged until your pet is comfortable drinking from it.
Let us help!
2-Year Warranty
For important safety information, please see the customer care guide.
United Kingdom 0800 046 1414
Radio Systems Corporation 10427 PetSafe Way Knoxville, TN 37932 USA
+1 865-777-5404
Radio Systems PetSafe Europe Ltd.
2nd Floor, Elgee Building, Market Square Dundalk, Co. Louth, A91 YR9X Ireland
+353 (0) 42 942 4122
petsafe.com
Radio Systems Australia Pty Ltd.
Suite 11001 Australia Fair Office Towers 36 Marine Parade, Southport, QLD 4215
+61 1800 786 608