DORMAN 80374 Interior Door Handle Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 80374 Interior Door Handle Instruction Manual
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully
DOOR HANDLE KIT INCLUDES
- DOOR HANDLE ASSEMBLY X 1
- SUPER GLUE X 1
- DRILL BIT X 1
- WASHERS X 6
- SCREWS X 6
REQUIRED TOOLS
- PHILLIPS SCREW DRIVER
- DRILL
STEP 1
Remove the door panel.
STEP 2
Remove the 6 connected points by using included drill bit.
STEP 3
Remove the spring and then the bracket
STEP 4
Remove the clips.
STEP 5
Remove the broken handle
STEP 6
Insert new metal part on the panel and then new handle.
STEP 7
Insert the two clips on handle
STEP 8
Put on the bracket and then put the spring back.
STEP 9
Put on the washer and then place 3-4 drops of super glue into the hole.
STEP 10
Wait for 5 seconds then fasten screw.
STEP 11
Repeat steps 9-10 for other 5 connected points.
STEP 9
Reinstall the panel.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to our motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
