SALUS SP600 Smart Plugs Instruction Manual
- June 3, 2024
- SALUS
Table of Contents
SALUS SP600 Smart Plugs Instruction Manual
Introduction
Smart Plugs go directly into an open outlet (like an extension of the outlet) giving a user connected control over the device plugged into the equipment. Salus offers standardized Smart Plugs for EU, UK and U.S. This product must be used with the Universal Gateway (UG600/UGE600) and the Salus Smart Home App. Go to www.salus-smarthome.com for the PDF version of the manual.
Product Compliance
This product complies with the essential requirements and other
relevant provisions of Directive 2014/30/EU, 2014/35/EU, 2014/53/EU and
2011/65/EU. The full text of the EU Declaration of Conformity is available at
the following internet address:
www.saluslegal.com.
Safety Information
- Use in accordance with the regulations.
- Designed to be used exclusively indoor.
- Keep your device completely dry.
- Disconnect your device before cleaning it with a dry towel.
Socket Switch
Ensure your socket switch is permanently on.
Connecting to WiFi
Application
Initialisation the LED
After initialisation the LED will start flashing continuously.
- Follow the on screen instructions.
- Once connected, the Smart Plug LED will stop flashing.
Smart Plug LED flashing
Operating the Plug
Exit gateway
If you want to exit the gateway, follow the steps below.
-
Press the button for 10 seconds.
-
Will flash red 5 times.
-
The LED will go off.
Support
SALUS Controls plc
SALUS House
Dodworth Business Park South, Whinby Road,
Dodworth, Barnsley S75 3SP, UK. Sales:
T: +44 (0) 1226 323961
E: [email protected]
Technical: T: +44 (0) 1226 323961
E: [email protected]
www.salus-controls.com
SALUS Controls is a member of the Computime Group
Maintaining a policy of continuous product development SALUS Controls plc
reserve the right to change specification, design and materials of products
listed in this brochure without prior notice.