VIOTEL 4-Channel Smart IoT Data Logger User Guide
- June 3, 2024
- VIOTEL
Table of Contents
CHANNEL SMART IoT DATA LOGGER
MOUNT
Mount the device firmly to your chosen location using a secure mounting
method: hidden side bolt mounting holes under flip tabs and/or pole mount
bracket for threaded holes.
USING THE MAGNET
Wherever instructed to tap the node using the magnet, do so at the spot
indicated “X”. Sequential taps must be performed within 3 seconds before the
device count resets.
The antenna must be connected firmly to the device before any operations can
occur.
CONFIRM STATUS
Tap Once – If the device is off, a solid blue light will
appear from the LED. Proceed to step 4. – If the device is on, a green light
then yellow
light will appear from the LED. The device takes 10 quick readings and uploads
them before returning to On status after a few minutes.
TOGGLE DEVICE ON
Tap Twice – This will turn the device on followed quickly
by 2 green LED flashes. The device may take serval minutes to update.
VIEW DATA
Please head over to your nodes Dashboard to begin seeing the data. Please
refer to the User Manual for more information and a full guide on this device.
For queries, email support@viotel.co
STATUS
GREEN| On
BLUE| Off
PURPLE| Diagnostic Mode
RED| Device is Busy
COMMS
BLUE| Communicating with server
YELLOW| Collecting GPS Coordinates
RED| Unable to Communicate
CHANNELS
CH1| Modbus/RS485
CH2| Strain Guage
CH3| 4-20mA (Current Loop)
CH4| 4-20mA (Current Loop)
OUR RESONANCE
Resonance describes the phenomenon of increased amplitude that occurs when an
external force or a vibrating system is equal or close to the natural
frequency of the system on which it acts. Leveraging decades of experience in
earthquake analysis and monitoring of mining seismicity, Viotel has a deep
understanding of resonance and has developed a unique series of asset
management solutions involving monitoring and analysis of vibrations and
waveforms. The Virtual SMART IoT Data Node is based on an ultra-low power
microprocessor. The node is self-contained with an internal battery, GPS, and
cellular (Cat-M1) modem with a pre-installed SIM card. The Virtual SMART node
is shipped with 4x adaptors for your sensors or alternatively, you can
purchase the plug-to-junction box adapter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>