VIOTEL Smart Barrier Monitor Node User Guide
- June 3, 2024
- VIOTEL
Table of Contents
Quick Start Guide
SMART BARRIER MONITOR NODE
-
MOUNT
Use a tension device to compress both the top and bottom wires on wire rope barrier. Wrap and secure the Strain band onto the compressed section. Remove the tensioning device from the barrier.
Attach the SMART Barrier device to the two wires on the barrier with steel cable ties. -
USING THE MAGNET
Wherever instructed to tap the node using the magnet, do so at the spot indicated “X”. Sequential taps must be performed within 3 seconds before the device count resets. -
CONFIRM STATUS
Tap Once
– If the device is off, a solid blue light will appear from the status LED. Proceed to step 4.
– If the device is on, a solid green light will appear from the status LED. Proceed to step 5. -
TOGGLE DEVICE ON
Tap Twice
– This will turn the device on followed quickly by 2 green LED flashes. The device may take serval minutes to update. -
VIEW DATA
Please head over to your nodes Dashboard to begin seeing the data.
Please refer to the User Manual for more information and a full guide on this
device.
For queries, email support@viotel.co
STATUS
GREEN| On
BLUE| Off
RED| Device is Busy
COMMS
BLUE| Communicating with server
YELLOW| Collecting GPS Coordinates
RED| Unable to Communicate
RECOMMENDED INSTALLATION LOCATION
It is highly recommended that the Viotel SMARTBarrier Node be installed on the
last full barrier section before the anchor block downstream of the flow of
traffic. The device can efficiently detect strain and crashes along the
entire length of the barrier from this position.
OUR RESONANCE
Resonance describes the phenomenon of increased amplitude that occurs when a an external force or a vibrating system is equal or close to a natural frequency of the system on which it acts.
Leveraging decades of experience in earthquake analysis and monitoring of mining seismicity, Viotel have a deep understanding of resonance and have developed a unique series of asset management solutions involving monitoring and analysis of vibrations and waveforms.
https://www.viotel.co/triaxial-tiltmeter.html
The Viotel Wireless Triaxial Tiltmeter features a high accuracy triaxial tilt
sensor and is self-contained with internal battery (solar panel optional), GPS
and cellular (CatM1) modem.
The tiltmeter is shipped pre-programmed and integrated. Simply mount the
sensor in the desired location and power on for reliable, continuous, real-
time monitoring.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>