ENGLANDER AC-W01CFB Ceramic Fiber Baffle Board Instructions
- June 3, 2024
- ENGLANDER
Table of Contents
ENGLANDER AC-W01CFB Ceramic Fiber Baffle Board Instructions
WARNING: STOVE MUST BE OUT (NO FIRE), AND COOLED DOWN BEFORE PROCEEDING.
ALWAYS FOLLOW ALL CODES.
Burner tube replacement
There are three different burnertubes in the top of the stove firebox.
To replace a tube, first be sure that you order the correct tube you need to
replace (front, middle, or rear – see
www.heatredefined.com and/or owner’s manual).
Then, using a 5/16” socket or open end wrench, remove the screw located on the
left side of the tube.
Be sure to keep the screw. Push the tube to the right then remove the tube
(pulling the tube back to the left after that side has been removed from the
hole). To replace, reverse the above procedure.
Make sure to install the tubes in the correct order. (Front to Back, as shown
below)
Ceramic fiberboard replacement
To replace a cracked or broken board, first remove the front burner tube.
Then, remove the board you need to replace. Install the new board (the two
boards should sit flush together on the tubes, side by side). Replace the tube
previously removed.
P.O. Box 206 Monroe, VA 24574
www.heatredefined.com
Phone: 800-516-3636
Fax: 434-929-4810