SALUS DI600 Smart Dimmer Switch User Guide
- June 5, 2024
- SALUS
Table of Contents
SALUS DI600 Smart Dimmer Switch
Introduction
DI600 is a Zigbee-controlled dimmer relay, that can be used for controlling different light sources. This product must be used with the Universal Gateway UG600/UGE600 and Salus Smart Home App
Product Compliance
This product complies with the essential requirements and other relevant
provisions of Directives 2014/53/EU (RED), 2011/65/EU and the expansion
2015/863. The full text of the EU Declaration of Conformity is available at
the following internet address:
www.saluslegal.com
2405-2480MHz; <10dBm
Safety Information
Use in accordance with the regulations. Indoor use only. Keep your equipment completely dry. Disconnect your equipment before cleaning it with a dry towel.
Technical Specification
| Technical Specification
---|---
Input Voltage| 100-240VAC 50Hz
Output| Max. 1.5 A
Max. Load| Dimmable LED 200W/220V Halogen 400W/220V
Dimensions| L: 45,5 mm, B: 45 mm,
H: 20,3 mm
IP-class| 20
Approvals| CE
RF frequency| 2.4GHz ZigBee
Wiring diagram
Notes for the diagrams
-
L: Live
-
N: Neutral
-
Out: Output to connect light source
-
+A1: Terminal for push switch 8-230V AC
(live) -
-A2:Terminal for push switch 8-230V AC
Push switch wiring connection
The DI600 can be controlled by wall push switch and 8 – 230V AC operational
voltage
With Single Push Switch
With Multiple Push Switches for Multiple Control Points
Power-up & Pairing
- Power on the DI600. The connected light will flash twice slowly.
- Short press the “Reset” button for 5 times continuously to enter DI600 pairing mode. Open Salus Smart Home app.
Click “Scan for equipment” to start pairing.
When DI600 has joined the network and the device is displayed in the App –
tick its box, click “Connect Equipment” and follow on-screen instructions
.
- Turn ON
- Turn OFF
- Dimmer percentage
The DI600 will change status when it is turned on or off in the app or by a push switch. The dimmer percentage will be shown in the app when DI600 is operated.
The OneTouch feature allows you to set operating rules for your device. For example, with one virtual OneTouch button, you can set all your DI600s to the same dimming value.
Factory Reset
Short press the reset button 5 times continuously. If the reset button is not accessible turn off the main power to the DI600 5 times continuously. The connected light will blink 3 times to indicate a successful reset. DI600 will enter pairing mode automatically just after factory reset.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>