SLX MICROSIM Home Golf MicroSimulator User Guide
- June 3, 2024
- SLX MICROSIM
Table of Contents
SLX MICROSIM Home Golf MicroSimulator User Guide
COMPONENTS
- SLX MicroSim Sensor device
- Swing Stick
- QR Code for Registration and License Key
- Single Cradle 4 (One is attached to the stick.)
- Multi Cradle 1
- Long Band & Short Band 1
- Charging Cable
PLEASE CHECK!
SLX MicroSim is delivered to you in deep sleep mode.
Wake up the SLX MicroSim device by connecting it to a power source using the
included charging cable.
On the surface of the single LED of the sensor,
There is a protective seal to prevent scratches. Please take off the film when
you use it.
Insturctions
**Register MicroSim Device
**
- Scan QR code received in box. Register SN and choose one free code for E6 License Key
- Scan by phone or visit: https://register.swinglogic.us
- Proceed to Download of E6 Application for iOS or PC.
Downloading E6 Connect Create an account
- If you are using the PC version of E6 CONNECT download the software https://e6golf.com/update/e6-connect/
- If you are using the iOS version of E6 CONNECT, download the software from the app store.
- Create an account, using the same email used for registering device with Swing Logic.
- Redeem License Key in E6 Connect
Select Tracking System Device
- Select “Tittle” or “Tittle X” device and press SELECT button.
NOTE
To use the SLX MicroSim device, you must select “Titde” or “Tittle X” in E6
Connect Home > Setting > Tracking System.
** LICENSE MANAGEMENT
https://portal.e6qolf.com : home > profile> setting > license
Use same email as steps 1 & 2**
Prepare the Device
-
Power up by tapping on the display twice or moving lightly.
(Red LED is blinking in connection ready). -
Mount device onto the Swing Stick or your golf club with cradle.
DEEP SLEEP MODE vs. SLEEP MODE!
The SLX MicroSim may have entered deep sleep mode. Wake up the device by
connecting it to a power source using the included charging cable.
SLX MicroSim will go into sleep mode after 10 minutes of no activity
Connect Device with E6 CONNECT
When E6 Connect runs, Tittle Device will automatically connect to E6 CONNECT.
The blinking red LED lights of device turns white and you can hear the voice
“Device connected”. If the device is not connected, see Manual Trouble
Shooting or contact support@swinglogic.us
Play!
- In the E6 CONNECT, start driving range or a round.
- With the Swing Stick, assume the address position and hold until SLX MicroSim device vibrates.
- Without waggling, begin your swing.
Thank you for purchasing the SLX MicroSim Stick Package. The composition of the package you purchased is shown in the picture below.
LIMITED WARRANTY
SLX MicroSim carries a 180 day limited warranty for product defects and replacements. No warranty exists for re-sold products or products not purchased directly from SwingLogic.us