iQ Align for CAL1 / CAL3 User Manual
- June 3, 2024
- IQ
Table of Contents
iQ Align for CAL1 / CAL3
INTRODUCTION
Important information: Read the manual carefully before using the device.
Inappropriate utilization may cause damages to the device, to the DUT (device
under test) and/or other components of your setup.
Keep these instructions in a safe place and pass them to any future user.
Intended use
Camera align system (for CAL1 and CAL3) based on a linear guidance in combination with a mobile mount allows adjustment of the DUT on X, Y and Z axes. Fix the end position with the locking wheels.
- Only suitable for indoor use.
Product variants
iQ-Align is available in two variants:
- • iQ-Align for CAL1
• iQ-Align for CAL3
Foreseeable missuse
Stucked linear guidance
If you cannot turn the wheels for the depth and horizontal alignment, unlock
the locking wheels.
GETTING STARTED
Scope of delivery
iQ-Align, attachment parts (for CAL1 or CAL3), manual
Commissioning
Assembly instructions for CAL1
iQ-Align mounted to CAL1
-
Unplug CAL1 from power and remove all cables. Lay your CAL1 on the side and unscrew the four feets of the device.
-
Place the forepart for connecting CAL1 with iQ-Align for CAL1 on the bottom side of the device. Now use longer screws M4x14 to fix it together with the feet to CAL1.
-
Rotate CAL1 on its back and mount iQ-Align for CAL1 on the intended position on the front side. Screw it on with two screws M5x8.
-
CAL1 with iQ-Align for CAL1 is now ready for use.
Assembly instructions for CAL3 iQ-Align mounted to CAL3 -
Unplug CAL1 from power and remove all cables. Lay your CAL1 on the back. Place iQ- Align for CAL3 on the intended position on the front.
-
Fix iQ-Align for CAL3 with 4 screws (M5x20, DIN7984) to CAL3 behind the front plate.
-
CAL3 with iQ-Align for CAL3 is now ready for use.
OPERATING INSTRUCTIONS HARDWARE
Camera positioning
Fix the DUT in iQ- Mobile mount.
Unlock the locking wheel and adjust the DUT position in X direction. Fix the
locking wheel and proceede with the other axes unless your DUT is placed
exactly in the center of the diffuser.
ADDITIONAL INFORMATION
Disposal instructions
After the service life of CAL3, it must be disposed properly. Electrical and
electromechanical components are included in CAL3. Observe your national
regulations. Make sure that CAL3 cannot be used by third parties after
disposing of it.
Contact Image Engineering if assistance for disposal is required.
TECHNICAL DATA SHEET
See annex for the technical data sheet. It can be downloaded at the website of Image Engineering as well: www.image-engineering.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>