SPECTRA T810 EFTPOS Mobile Terminal Installation Guide

SPECTRA T810 EFTPOS Mobile Terminal

Layout& Function Descriptions of T810

Main Unit & Accessories
Features at a Glance

Installation of SIM, SAM & Micro-SD Card

BATTERY INSTALLATION

Paper Feeding Procedure

1. Lift up the Paper Tray Lever
2. Pull the Paper Tray Lever backward
3. Place the paper roll into the tray as shown
4. Close the Paper Tray Cover

How to Operate

Turn On/ Off Procedure

• If the terminal is equipped with a charging battery during first-time use, please connect the power adaptor and charge the battery for 3 hours.On –
• The power is on whenever plugged. If the terminal is unplugged, press thekey for several seconds to turn on the terminal. When the terminal displays the application idle screen, it is ready for operation.
• Off- Disconnect the power adaptor. Keep on pressing the key for several seconds to turn off the terminal.

Swipe Card & Insert Card

Rechargeable Battery Safety Guideline

Prohibition: Improper handling of the Li-Polymer battery is hazardous, the following forbidden activities must be avoided:

• DO NOT use NON-SPECTRA provided battery in SPECTRA POS Terminal
• DO NOT use a charger that is not specifically designed to charge Lithium Polymer Battery
• DO NOT operate the terminal, charge up or store the battery under high . temperature (under direct sunlight or inside a roasting vehicle) or dose to heat source (fire, heater)
• DO NOT store the battery in the external charger. After charging up, the battery should be removed, even though power is disconnected
• DO NOT use damaged battery, e.g. Swelled case broken, strange odor and chemical leakage
• DO NOT knock, crash or press the battery
• DO NOT submerge the battery into water
• DO NOT heat the battery or dispose in fire
• DO NOT solder the battery
• DO NOT disassemble the battery
• DO NOT short or puncture the battery

Battery Operation & Charging Guideline

• The best temperature for battery operation is 0’C ~ 45°C. DO NOT place the terminal in hot space or poor ventilated space. Ensure good ventilation for cooling
• DO NOT leave battery un-attended when charging. You should closely monitor the charging process & react to potential problem should they occur
• Do always check that batteries are physically and electrically undamaged before charge or oischarge
• Battery charging must be kept away from infiammable material and on a non conductive and nonflammable stable surface by:

  • Terminal built-in charger: install battery to the terminal, then apply power

  • SPECTRA Supplied external charger

• When new terminal is received, please charge the battery fully up
• If the battery gauge indicates battery low, charge up the battery at once
• Battery always selr-discharges. Long period of discharging will deteriorate the capacity and life of the battery. Please re-charge the battery weekly for normal operation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>