EEZEE POWER GEN2 Clear Vision Light Bar Instructions
- June 1, 2024
- EEZEE POWER
Table of Contents
EEZEE POWER GEN2 Clear Vision Light Bar
If you prefer to use a connector of your choice, you may cut the DT connector off. This does not affect the warranty. Please make sure you remember the cable positions before cutting so that you know which cable has which function.
PARTS INCLUDED
- A. 2x Universal side mounting bracket
- B. 2x Universal center mounting bracket
- C. 2x M8 stainless steel bolts
- 2x M8 Allen bolts
- 2x M8 rubber washers
- 2x M8 washers
- 2x M8 washers
- 2x M8 spring washers
- 2x M8 nuts
- D. 6 PIN DT Deutsch connector (male)
TOOLS REQUIRED
- Allen keys (included)
- Wrench 13 mm
DT Connector
DT Connector wiring position
DT Cable Position| ****
Cable Function
| ****
Cable Colour
---|---|---
1| Grounding (Negative – )| Black
2| Driving beam (9-36V DC+)| Red
3
| Amber Beacon (9-36V DC+)| Green
4
| White position light (9-36V DC+)| ****
White
5
| ****
Beacon choice (5 flash patterns) (9-36V DC+)
| ****
Blue
6
| Amber position light (9-36V DC+)| ****
Yellow
Disclaimer
- All information in this guide has been prepared with great care. Although we make every effort to ensure that they are correct, errors may occur. Eezee Power cannot be held liable for errors, changes, outdated information and/or omissions.
- This user guide aims to assist you in doing your installations and is for information purposes only. Eezee Power will not be responsible for any damage caused by the failure to install the product according to these instructions.
- If you do not understand the instructions and/or you do not feel confident enough to tackle the installation, you should have the product installed by a professional.
General guidelines
- Never connect this product to a source lower than 9 or higher than 36 Volts.
- Always use a relayed wiring harness. Never connect directly to the battery.
- Use lubrication on all stainless steel hardware to prevent locking.
- Do not open or modify the product without explicit Eezee Power consent.
- Check local regulations to legally install and use the product.
- The cooling element on the back heats up when the product is in operation, this is normal.
- Do not use a jet washer on the lamp. Do not use an automatic car wash with lamps installed on the car.
Product care information
- Wash the lamp regularly, just as you would care for your vehicle.
- Hand-wash with a mild soapy water or household glass cleaner to remove dirt, grime and insects.
- Never use dish soap, wax, abrasive cleaners, polishers or products made for normal paints.
- Use a soft wash mitt, cotton cloth or microfiber cleaning cloth. Never use terry cloth or paper towels.
- To enjoy the matte appearance for many years, you can buy a no-shine matte car wash soap.
Warranty
Our warranty only applies to manufacturing or design defects and does not
cover misuse, modification, improper installation, accident damage, normal
wear or finish failure caused by the usage of the wrong cleaning agents.
Please check the terms and conditions on our website for further details about
the warranty procedures.