SEALEY GH60A Garden Hose Reel Instructions
- June 17, 2024
- SEALEY
Table of Contents
SEALEY GH60A Garden Hose Reel Instructions
Thank you for purchasing a Sealey product. Manufactured to a high standard,
this product will, if used according to these instructions, and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE
INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS &
CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT
IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE
‘WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE
SAFETY
O WARNING! Disconnect the hose reel from the water supply before changing
accessories, servicing or performing any maintenance.
v Maintain the hose reel in good condition v Replace or repair damaged
parts. Use recommended parts only. Unauthorised parts may be dangerous and
will invalidate the warranty.
x DO NOT operate the hose reel if any parts are damaged or missing as
this may cause failure and/or personal injury.
x DO NOT use for any purpose other than that for which it is designed
x DO NOT operate the hose reel when you are tired or under the influence
of alcohol, drugs or intoxicating medication
x DO NOT direct water from the water hose at yourself or others
INTRODUCTION
Lightweight tubular steel frame with tough plastic snap-together parts – no
tools required. Integral handle for easy use and portability.
Two angled 1/2” hose connectors that will fit most pipe systems. Reel holds up
to 60m of Ø13mm hose.
CONTENTS
Check parts against the parts list below. If anything is missing, contact your Sealey stockist.
| PART NO. | DESCRIPTION | QTY |
|---|---|---|
| Stand Holder | ||
| Metal Stand (longer) | ||
| Metal Handle (shorter) | ||
| Reel | ||
| Reel Cross Bar | ||
| Crank Handle | ||
| Elbow Hose Connector Set | ||
| Male Adaptor | ||
ASSEMBLY
Attach the handle and feet to the stand holder **(fig.1)
Attach the two reels together using the two cross bars (fig.2).
Attach the crank handle through the stand holder (fig.3).
Attach the hose and connectors (fig.4).
To fit your hosepipe to the reel, simply connect your hose to the hose end
connector inside the reel, and wind the hose in.
To connect your reel to your water source, you will need to either cut a
length from your garden hose or use an individual extension hose, then fix the
hose to the outside of the reel using a hose end connector and attach the
other end to your tap using a hose end connector and tap connector”.
NOTE:** Hose pipe not included.
| ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations| 
---|---|---
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 [email protected]
www.sealey.co.uk
