A-iPOWER SUA2700iD 2700iD Watt Dual Fuel Inverter Generator User Guide

A-iPOWER SUA2700iD 2700iD Watt Dual Fuel Inverter Generator

Unpack Generator: Remove generator, accessories, inserts and Literature from carton. If any item is missing or damaged, contact our product service department at 855-888-3598.

Included Items

WARNING
This Quick Reference Guide is not substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and underdstand the operator’s manual before using this product. All pages references to the operator’s manual.

Add Lubricant and Fuel

• Use a funnel to pour provided engine oil into engine. Fill to the upper mark of the oil dipstick H.
• Use clean / fresh regular UNLEADED gasoline with a minimum 87 octane.

Start Generator

Move generator outside to a flat, level surface, away from doors, windows and vents.

WARNING Do not overload generator or electrical cords. Consult operation manual.

Select the Fuel Source (Gasoline)

1. Make certain the propane tank is fully closed.
2. Turn the fuel source switch to the gasoline position.
3. Pull the choke knob out to the “START” position.
4. Turn the engine switch to the “ON”(l) position.

5. Pull cord starter to start engine.
6. As soon as engine starts and warm up, push the choke knob in to the “RUN” position
7. Plug in items to be powered, using only grounded extension cords.

Select the Fuel Source (Propane/LPG)

1. Fully open the Propane/LPG cylinder knob.
2. Turn the fuel source switch to the propane/LPG position.
3. Turn the engine switch to the “ON”(l) position.
4. The Propane/LPG priming button is located on the propane hose. Press the button for 3 – 5 times to prime the engine.

5. Push the choke knob in to the “RUN” position.
6. Pull cord starter to start engine.
7. Plug in items to be powered, using only grounde extension cords

Shutdown and Storage

1. Remove any load from the generator.
2. Turn the engine switch to the “OFF”(0) position.
3. Turn the propane/LPG cylinder knob to close position.

If generator is to be stored for longer than 30 days, refer to The operator’s manual for further Instruction.

Changing Fuels

1. Disconnect all electrical loads from the generator.

2. Turn the engine switch to the “OFF”(0) position.

3. Gasoline to propane/LPG

   • Fully open the Propane/LPG cylinder knob.
   • Turn the fuel source switch to the propane/LPG position.

Propane/LPG to Gasoline

  * Make certain the propane tank is fully closed.
  * Turn the fuel source switch to the gasoline position.

4. Start the engine (generator).

Questions? Call 855-888-3598 or email support@a-ipower.com

¿Tiene preguntas? Llame al 855.888.3598 o escriba a support@a-ipower.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>